looks like one is a bit slower than the other, is it?
____________________________________
"How soon we forget history...Government is not reason. Government is not eloquence. It is force. And, like fire, it is a dangerous servant and a fearful master."
- quoted by George Washington
“America will never be destroyed from the outside. If we falter and lose our freedoms, it will be because we destroyed ourselves.”
Abraham Lincoln quote
looks like one is a bit slower than the other, is it?
The car in the video has prototype modules installed, each being a different design. There should be no difference in how they work, most likely the video editing software and the upload has caused a problem.
The modules being sold and shipped are the best design we have tested. They all flash/blink/ and sequence at the same rate.
my brother and i litterally just got done putting mine in and they work awesome. thanks again!
____________________________________
1997 crystal white cobra/ upr underdrive pulleys, k&n intake, bbk offroad x-pipe with mac mufflers, eibach lowering spring with ford racing c&c plates, king cobra clutch, upr short throw shifter, diablo chip with dyno tune, 3" 2000 cobra r hood, chrome fr500's 18x9 and 18x10 deepdish, cross drilled brembo rotors, clear corners with envoy fog lights, full H.I.D conversion, 4.30 gears and trac loc rebuilt, 2003 mustang center console, l.e.d. tail and reverse lights, fr500 steering wheel, polished billet door handles, upr polished cup holders and shifter ring, shortrunner intake and imrc delete, autotrix sequential taillight kit, redline goods carbon fiber shifter and e-brake boots, redline goods carbon fiber armrest cover, custom trunk box with 2 10" rockford fosgare p210's, 500 watt rockford amp, all rockford wires and speakers throughout the car, kaenen s-281 wing, clear bumper reflectors, clear l.e.d. 3rd brake light, etc...
Well I cant give away all of our secrets but resistors are a small part of how our circuit works. There are several electrical components on each modules circuit board.
The splice-in kit is the same as the plug-and-play kit, but with the plug-and-play you get two new ford harnesses with our modules pre-wired in.
is ther a way to swap out resistors or when i place an order get different one more likly higher resisters to slow down the sequentials to me they are a little to fast
so with the splice in kit do I just match wire for wire and tape it off? That easy?? Also are you still offering the 15%?
Go to the website and check out the install instructions for the mustang tail light sequencers. Sorry but the discount was over on the 1st of September.
Quote:
Originally Posted by Mystic03
is ther a way to swap out resistors or when i place an order get different one more likly higher resisters to slow down the sequentials to me they are a little to fast
No, there is no way to modify circuit board once they have been sealed. We have something coming very soon that will cure all the "speed" issues that some have mentioned.
coming soon...ported blower w/ 2.80upr 4#lower, - New dyno numbers coming soon! 
but resistors are a small part of how our circuit works. There are several electrical components on each modules circuit board.
I was sleeping on the job.
Thank you for leaving me my first 
Linear Mode
