After seeing the Range Rover Aluminum block coffee table last year I been dying to make my own engine block coffee table.
After I messed up my 4.6 mustang gt engine last year I decided it was time to make my own.
I basically bolted together two sets of rods and pistons then inserted them into the cylinders, so on one side the piston is upside down and pushed all the way down the cylinder, the other half is right side up and holds the glass up, the bottom piston/rods are gt ones and the top ones to hold the glass are stock cobra ones(flatter then gt ones).
I also decided to make my own matching cupholder/coaster, this was achieved by milling out the center section of the piston so the can would fit!
After I messed up my 4.6 mustang gt engine last year I decided it was time to make my own.
I basically bolted together two sets of rods and pistons then inserted them into the cylinders, so on one side the piston is upside down and pushed all the way down the cylinder, the other half is right side up and holds the glass up, the bottom piston/rods are gt ones and the top ones to hold the glass are stock cobra ones(flatter then gt ones).
I also decided to make my own matching cupholder/coaster, this was achieved by milling out the center section of the piston so the can would fit!