So I just installed my autotrix sequential tail light kit tonight. I suggest using snap wire connectors along with the crimp on butt connectors because its hard to stuff two or three wires into one inlet. And when combining the GRD wires from the L3 socket and harness it is very difficult because when you cut them in half it is hard to angle both of them together into a butt connector. But overall I am very pleased with how things turned out. The instructions were very clear and it only took about 30 minuets to install
Here is a quick video recorded with my macbook. The quality is not very great, but you get the idea. I'll upload a better video sometime during the week
[ame="http://www.youtube.com/watch?v=b0YhnJoEpuY"]YouTube- Movie on 2010 01 03 at 20 57[/ame]
Linear Mode
