How to Hook 40A Kenne Bell Boost a Pump up on 99-04 Mustang Gt Without wiring upgrade With Pic's
Last edited:
How to Hook Kenne Bell Boost a Pump up on 99-04 Mustang Gt
- Thread starter Capngizmo
- Start date
-
- Tags
- boost a pump fuel kenne bell
Where to hook it up? in trunk behind the plastic/Felt insulation on the drivers side
Last edited:
Unhook the Inertia Switch
Unwrap the tape from the wires hooking to the inertia switch Cut the Pink Wire with the back Stripe about half way leaving aprox 2" on the plug side
Put heat shrink on the wires hook the Fused red wire of the boost a pump to the wire coming from the inertia switch Solder heat shrink and Tape the wires
Now hook the Non fused red wire of the Bap to the pink wire with black stripe going into the wiring harness solder heat shrink and tape
soldered and heat shrink added
Taped back up
next install heat shrink on the black wire put the ground lug on
Solder the lug to the wire
Push the heat shrink up and heat it
next tape it
Ground it where the other grounds come out of that wire loom just in front of the FPDM
Solder the lug to the wire
Push the heat shrink up and heat it
next tape it
Ground it where the other grounds come out of that wire loom just in front of the FPDM
Now mount the BAP (do not drill through the fender) I used 3m tape and 2 of the self tapers on the top
Now I did hook the hook up the BAP Controller. I used 3m tape to install it beside the Inertia switch. Turned it all the way up so the ECU can have complete control of the power.
Thats it tucked the rest of the wiring behind the FPDM used wire ties to tie it all together...
Users who are viewing this thread
