We are an Authorized Eaton Remanufacturer
When you send in your supercharger we ask that you enclose a note with your name, phone # and return address.
Pack Well esp snout/pulley area. Take off All removable parts.
(if you send in the boost by pass for us to adjust properly pack separately)
Once the blower,throttle body and plenum are in our shop we open the box and number
ALL components we number the note and input in our computer files.
This insures that Everyone gets back their same Blower. We call you that day go over job instructions with you and get any other info we need.
We fully disassemble your blower and front drive snout and evaluate it's condition. All bearings and seals are inspected, rotors are checked for flaking and tip scouring.
The blower case is ported achieving the
CORRECT balance of Low pressure to High pressure. (Low pressure meaning the inlet side and High pressure the exit side)
All Airflow test data recorded with a SF 600 SuperFlow Flow bench. Careful attention is paid to ALL areas to achieve the Highest Airflow rates and still Retain case rigidity ----Designs are constantly being tested and updated to assure you the Largest HP gains available-- GUARANTEED.
All Lightning Truck blowers have rotor to case rub. We at Stiegemeier Porting have developed a machining process that increases clearance in these areas between your rotors and case
This is not an option just part of the Stiegemeier process to insure you the customer has
No pre-mature failures. The rotors are profiled, blueprinted and timed to the case.
After porting All gasket surfaces are checked for flatness and machined if necessary.
The machined parts are put threw a 3 phase cleaning process the last being a high pressure 190 degree rotisserie wash.
If the rotors are to be chemically stripped which we Highly Recommend for any rotors that are epoxy coated and being spun faster than the OEM setting. Rotor flaking leads to blower failure. Some rotors wear and some flake.
All superchargers are assembled with factory correct Full Synthetic grease and oil.
All fasteners are torqued to spec after assembled All blower are spun at speed and checked with an amplified hearing system to insure you of a perfect assembly. All superchargers are cataloged, numbered and dated.
We take our shipping Seriously-We double box with, bubble wrap, protective shield for snout and packing peanuts.
We do stock all gaskets, pulleys and plugs ect. We supply you with tech tips, instructions READ THESE.
We are available to answer any of your questions you might have.
We have a very friendly and knowledgeable staff.
ONCE YOU ARE A STIEGEMEIER CUSTOMER YOU ARE A CUSTOMER FOR LIFE!
We have 1-3 day turnaround. Cores available. Front drive rebuild recommended.
I will always GUARANTEE more HP Per Dollar than any Competitor .
2800+ Ported Eaton Units complete to date--
Engine Air Flow Specialists for over 25 years.
We are very dedicated to our customer service and stand behind our workmanship 100%
Thank you
Stiegemeier
StiegeSplash
636-949-2275
More Information, customer testimonies, data, pictures, graphs, ect...
Supercharger Q&A, Moderated by Dyno Bob
Stiegemeier Professionally ported and Exterior Show polished Supercharger.
Call, E-Mail, PM us with any questions or concerns.
Office hours 8:30 am-5:30 pm
although we are usually out there later. (Central time) Monday - Friday. Saturday someone is usually in the shop and will answer your call, please leave a message if we can not get to the phone, since we do Dyno mostly on Saturdays.
Linear Mode
