• Welcome to SVTPerformance!

Clutch issues Need Help

Discussion in 'SVT Focus' started by RDLightning01, Jan 15, 2013.

  1. RDLightning01

    RDLightning01 Young Svt Poster Established Member

    Messages:
    762
    Joined:
    Aug 17, 2005
    Location:
    Princeton, IA
    I replaced my clutch with a CFM Unit. It was installed by a Ford service tech that i am distant friends with. Anyways about 15k miles later at a stop light i lose all ability to disengage the clutch. So to get it off the road i shut off the car and started it in first gear and was able to clutchless upshift home. Im not low on fluid but the master cylinder has been leaking. and the clutch is very difficult to push in. Any ideas? Any help is very much appreciated.
    Thanks
     
  2. LeKiD

    LeKiD New Member Established Member

    Messages:
    291
    Joined:
    Jan 29, 2005
    Location:
    Drummondville,Qu├ębec
    Hard to push , from the top or near the floor.

    I would start to replace the master , they are know to fail and leak on the floor mat.
     
  3. RDLightning01

    RDLightning01 Young Svt Poster Established Member

    Messages:
    762
    Joined:
    Aug 17, 2005
    Location:
    Princeton, IA
    feels like the fluid builds pressure and nothings moving. Replaced the master today and no luck. So now out with the tranny again. :nonono:
     
  4. loc0gring0

    loc0gring0 New Member Established Member

    Messages:
    291
    Joined:
    Jun 8, 2008
    Location:
    springfield
    sounds like a master.. takes about 20 min to swap
     

Share This Page