• Welcome to SVT Performance!

tremec tko install in a 97 cobra....?

Discussion in 'SN95 Cobras' started by on-3svt, May 8, 2005.

  1. on-3svt

    on-3svt New Member Established Member

    Messages:
    142
    Joined:
    Nov 22, 2004
    Location:
    st.louis MO
    has anyone put a tremec tko in a 96 -98 cobra ?

    need to find out what the spacer size is between the

    the transmission mount and the crossmember.

    got to get the drive train angle correct to get rid of the vibrations.
     
  2. SnakeBite98

    SnakeBite98 HIGH-REV HORROR Established Member

    Messages:
    996
    Joined:
    Jul 30, 2003
    Location:
    San Diego
    did it, the easiest way to deal with it is to order the bracket from Pauls High Performance and then you can kee the crossmember where it is and then just run the bracket from the tranny to the crossmember giving you the correct angle. the bracket is like 50 bucks.
     
    Last edited: May 8, 2005
  3. duane v

    duane v New Member Established Member

    Messages:
    1,528
    Joined:
    Aug 23, 2003
    Location:
    Coveeeeena SoCal
    If you dont opt to get the PHP tranny adapter, you will have to machine an aluminum 1.125" x 1.125" sq. x 6" in length to sit above the tranny mount..Also lose the stock tranny mount and get an Energy suspension tranny mount...DA snake boy!!!!
     
  4. on-3svt

    on-3svt New Member Established Member

    Messages:
    142
    Joined:
    Nov 22, 2004
    Location:
    st.louis MO
    got the energysuspension trans. mount.. big difference.
    just got a real bad vibration almost the whole time the car is moving .
    moved the cross member up didnt know about the bracket, but i think i would rather have the spacer with the cross member up. does it make a difference which way its done?
     
  5. on-3svt

    on-3svt New Member Established Member

    Messages:
    142
    Joined:
    Nov 22, 2004
    Location:
    st.louis MO
    how sturdy is the php braket and how much does it weigh.
     
  6. SnakeBite98

    SnakeBite98 HIGH-REV HORROR Established Member

    Messages:
    996
    Joined:
    Jul 30, 2003
    Location:
    San Diego
    its like an inch thick piece of steel, doesn't seem to heavy but it is very sturdy. i went with the bracket because i didn't have time to deal with the measuring and fabing cause im getting ready for finals. its just a bolt and go.
     

Share This Page