What's new

Latest posts

Latest profile posts

Where are you located in WI? Concerning your question, you should be okay if all you did was unloosen and retighten the bolts. The sealant had started to dry after a couple of hours but wasn't fully cured yet.
What do I need to do to have someone unregister my profile? I’ve submitted multiple messages to the contact us portal.
03cobra#694
03cobra#694
They don't delete profiles. What do yo need?
K
kenf
Removed is what I need. How else do I need to write it? Your warm welcome pissed me off. I don’t want to be associated with the forum or used for my data.
03cobra#694
03cobra#694
They will not delete you. What's the issue?
Hi SdFoxbody, I wanted to reach out and ask about chassis stiffening a coyote foxbody in regards to how can I do it properly and what I need in the case for good street power builds, and a fun track car ?

I’ll most likely aiming to be the 600-700 HP range but maybe in the future I’ll take it up to the 900 range but that’s for a later time.
S
Sul303
Is there any possible like stiffening kits that you might recommend as I’m trying to steer away from fabricating anything as I really don’t trust many of the fabricators here (outside the US).
S
Sul303
I currently have the Detroit Speed Chassis stiffening kit but I don’t know if it can allow any room of growth really as their website says 400+ hp and I don’t think that + is equal to an additional 200 hp you know what I mean ?

But I haven’t installed it yet.
SdFoxbody
SdFoxbody
Is their strengthening kit a set of subframe connectors? And what country are you in currently?

Top