I am selling my 2007 GT500 that only has 9,480 miles. ( Note the mileage is slightly different than in the title)
I hate to sell it but I have a better use of funds than for a vehicle that sits in the garage.
I have never ran the 1/4 or had it dynoed so I have no concrete numbers but I know most of y'all on this forum know enough to draw your own conclusions on estimated horsepower.
Overall it is in great condition. There are (I think) 3 small rock chips, the aftermarket stripes on the hood could use a better set (since the ones that came with the aftermarket hood are not durable at all) and the front splitter has a scuff on it. I have shown, as best I can, these blemishes in the pictures.
I am located right outside of New Orleans.
I am asking $30,000 as is.
Please text me at 985-445-6838 if you are interested.
A list of all of the mods:
Tuned by John Lund
Upper Control Arms BMR
Upper Control Arm Mount BMR
Lower Control Arms J&M
Relocation Brackets J&M
Lowering Springs Eibach Pro
Caster/Camber Plates J&M
Panhard Bar BMR
Panhard Bracket BMR
Intercooler Reservoir True Forged(Not currently installed)
Supercharger Whipple 3.4 Crusher
Throttle Body Whipple Mono-Blade
CAI/Mass Air Whipple
Spark Plugs
Boost Gauge Autometer Cobalt
Fuel Pressure Gauge Autometer Cobalt
Wideband Air/Fuel Innovate
A Pillar gauge mount Speed of Sound
Hood Cervini's Cowl
EGR Delete Lethal
Hood Pins Shelby
Hood Pin Install Kit Shelby
J&L Grill Bezels J&L
Cup Holder switches Speed of Sound
Heat Exchanger Revan Racing
Radiator Revan Racing
Thermostat Reische
Alternator PA Performance 130 AMP
I hate to sell it but I have a better use of funds than for a vehicle that sits in the garage.
I have never ran the 1/4 or had it dynoed so I have no concrete numbers but I know most of y'all on this forum know enough to draw your own conclusions on estimated horsepower.
Overall it is in great condition. There are (I think) 3 small rock chips, the aftermarket stripes on the hood could use a better set (since the ones that came with the aftermarket hood are not durable at all) and the front splitter has a scuff on it. I have shown, as best I can, these blemishes in the pictures.
I am located right outside of New Orleans.
I am asking $30,000 as is.
Please text me at 985-445-6838 if you are interested.
A list of all of the mods:
Tuned by John Lund
Upper Control Arms BMR
Upper Control Arm Mount BMR
Lower Control Arms J&M
Relocation Brackets J&M
Lowering Springs Eibach Pro
Caster/Camber Plates J&M
Panhard Bar BMR
Panhard Bracket BMR
Intercooler Reservoir True Forged(Not currently installed)
Supercharger Whipple 3.4 Crusher
Throttle Body Whipple Mono-Blade
CAI/Mass Air Whipple
Spark Plugs
Boost Gauge Autometer Cobalt
Fuel Pressure Gauge Autometer Cobalt
Wideband Air/Fuel Innovate
A Pillar gauge mount Speed of Sound
Hood Cervini's Cowl
EGR Delete Lethal
Hood Pins Shelby
Hood Pin Install Kit Shelby
J&L Grill Bezels J&L
Cup Holder switches Speed of Sound
Heat Exchanger Revan Racing
Radiator Revan Racing
Thermostat Reische
Alternator PA Performance 130 AMP
Last edited:
