How-To: Factory Reverse Camera to Base Model

DeeJayTJ

New Member
Established Member
Joined
Jun 7, 2011
Messages
28
Location
Houston, Tx.
Hi! I dont think I've ever really contributed much here (if ever at all actually)

So thought I would share this: (since this answers some of the questions I had)
Just wanted to show off my new camera spoiler that I added to my Base Model 2013.

IMG_20141010_135312-XL.jpg


IMG_0433-XL.jpg


IMG_0432-XL.jpg



Wire harness from spoiler

IMG_20140112_160611.gif


Ford pigtail

20131207_224315_zps9334cb60.jpg


As forum member Siber Express says "The colors change in the Harness you plug into.
The Blue wire does not get used, the Red, 2 whites and 2 blacks do.
If you go by the 11 wiring diagram the red will be #1.
Here is the replacement plug you need "


Switched 12v = RED Pin 1
Ground = BLACK Pin 3
Video Sheild = BARE SHEILD - pin 4 (also black and i didnt connect it to anything)
VIDEO + WH-GN = WHITE Pin 6
Video - BN-VT = WHITE pin 7

As for the mirror wiring:

Switched 12v - fuse tap to fuse 41

2013Mustang%202.jpg


green reverse wire from mirror was tapped into the BCM B module (body control module B) which is in the trunk behind the carpet on the right side behind where the factory amplifier would be if I had one. its a black 24pin connector. Pin 5 which is GREEN for the 2013s, the left reverse lamp signal.

Camera power 12v - fuse tapped to fuse 29. As for the ground wire, well I just grounded in the trunk on a metal bolt behind the carpet.

2013Mustang%201.jpg
 

DeeJayTJ

New Member
Established Member
Joined
Jun 7, 2011
Messages
28
Location
Houston, Tx.
its just from ebay, it was like 144$ ill pm u the seller. I'm very happy with the quality of it for being a cheap mirror, the quality is INCREDIBLE on the 4.3 inch 16x9 screen. Most of the mirrors I've seen were 2x2 and square.
 

Users who are viewing this thread



Top