Limp mode after trans pan swap

Mac 108

Member
Established Member
Joined
Jun 20, 2008
Messages
62
Location
Memphis
2009 P71 Crown Victoria with 2v 4.6 and 4R75E

Car was running fine with no problems initially until I swapped transmission pans.

I removed the stock pan, replaced the filter with a new Motorcraft piece and then installed an aluminum deep sump pan and refilled with Mercon LV. I double checked the old filter to make sure that the old o-ring was removed along with the filter.

After doing the trans work, the car went into limp mode. It shows the Wrench light and Check Engine Light. It barely idles if it runs at all and dies if you put it into gear.

It is showing the following codes:
P0135 HO2S Heater Circuit Conditions
P0155 HO2S Heater Circuit Conditions
P0403 Exhaust Gas Recirculation "A" Control Circuit
P0443 EVAP Canister Purge Solenoid or VMV Circuit Conditions
P0743 TCC Circuit Conditions
P0766 Shift Solenoid "D" Performance/Stuck Off
P0962 Pressure Control Solenoid "A" Control Circuit Low


What could I have possibly done wrong to cause this? It's the most bizarre auto problem I have ever had and I have no idea what I did to screw this up.
 

svtguy

Active Member
Established Member
Joined
Mar 24, 2001
Messages
726
Location
Iowa
Check Fuse F21, a 15amp fuse in the battery junction fuse block.

Paul
 

Users who are viewing this thread



Top