I have project to swap mt82 transmission in a sn
i know the bell housing bolt on 4.6 2v modular. The only problem may come from the crank, with a 8 bolts crank, perfect, the coyote flywheel has 8 holes but
for a 6 bolts crank, his cause problem because the pressure plate of a coyote has 9 holes instead of 6 holes for the 4.6, therefore not possibility to use the flywheel of the 4.6.
or use a disk of coyote and a pressure plate of 4.6 .
For the driveshaft i use a yoke from 8.8 2011 but for length i dont know if work
Have you any suggestion :rollseyes
i know the bell housing bolt on 4.6 2v modular. The only problem may come from the crank, with a 8 bolts crank, perfect, the coyote flywheel has 8 holes but
for a 6 bolts crank, his cause problem because the pressure plate of a coyote has 9 holes instead of 6 holes for the 4.6, therefore not possibility to use the flywheel of the 4.6.
or use a disk of coyote and a pressure plate of 4.6 .
For the driveshaft i use a yoke from 8.8 2011 but for length i dont know if work
Have you any suggestion :rollseyes
Last edited:
