So, I just got my car put back together, and part of my upgrades was installing a 26 spline input shaft. I set it up correctly, but when the transmission gets warm, it makes excessive rattling noises between shift when the clutch is in. No noise at all when under a load. I pulled the transmission again yesterday to make sure all was good, and it was. I am not sure if it done it before because I had a bad throw out bearing. Any suggestions on what it could be? It is a Tremec shaft that I installed and I am run Mobil 1 synthetic ATF.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk