Could anyone point me in the direction of one of these diagrams? Not the supercharger belt route, but the inner belt.
Need the belt route diagram for the inner drive belt.
- Thread starter DSG2003SVT
- Start date
If you have any questions, feel free to PM me.
Thank you sir. That's how I thought it went, but I just wanted to make sure. :thumbsup:
Just wondering, where can i find a replacement inner belt? .. mine is about go
thanks!
thanks!
RockAuto.com :thumbsup:
Most serpentine belts can last up to 30K or more depending on conditions. I would recommend on inspecting it for cracks or frays whenever you change your oil.
A little rule of thumb when trying to figure out belt routings: Just look at the pulley surface, if it is flat then the flat side of the belt should be touching it, if it is grooved then the grooved side of the belt should be touching it. :read:
Edit: Just realized how old this thread was!
Last edited:
got over 200k on mine before changing..and only changed it cause we had it off
cool thanks!
i just noticed a couple weeks ago tht my serpentine belt was cracked and after running it at the track and a few daily trips i noticed it's about to go
thanks for the info--how hard is it to replace?
i just noticed a couple weeks ago tht my serpentine belt was cracked and after running it at the track and a few daily trips i noticed it's about to go
thanks for the info--how hard is it to replace?
belt
all depends...hardest part i had was the stock lower pully....
it has a 14mm allen bolt.......get 1/2 inch drive 14mm socket.long half inch braker bar,,and 4-6 foot piece of pipe,to use to pull on,,,its tight,,once cracked ,it spins off by hand from thier
after thats loose is cake...:beer:
goodluck
all depends...hardest part i had was the stock lower pully....
it has a 14mm allen bolt.......get 1/2 inch drive 14mm socket.long half inch braker bar,,and 4-6 foot piece of pipe,to use to pull on,,,its tight,,once cracked ,it spins off by hand from thier
after thats loose is cake...:beer:
goodluck
cool thanks again!
one more question--do i have to remove all the front pulleys from the supercharger belt in order to remove and install the new serpentine belt?
one more question--do i have to remove all the front pulleys from the supercharger belt in order to remove and install the new serpentine belt?
the s/c shield has to come off for just changing sc belt
the inner belt is the one that the crankshaft pully needs to come off
the inner belt is the one that the crankshaft pully needs to come off
ok thanks.. attempting this right now
not sure about the stock pulley, but I replaced the inner belt without removing the lower pulley, which was a Metco lower. we loosened a couple other things, but able to change it without removing a bunch of stuff.
you may need to cuss at it a few times, use a flathead or prybar to help rotate the belt sideways to go between a couple things.
you may need to cuss at it a few times, use a flathead or prybar to help rotate the belt sideways to go between a couple things.
Yeah, with the stock pulley the cage keeps you from putting it on or off so you have to remove it.
Then you go through the sequence of fishing the belt where it needs to be like you mentioned.
Users who are viewing this thread
