2010 GT500 with just over 10,000 miles. I have invested well over $20,000 in mods. I am the original owner, ordered it in 2009. Never seen weather. Very clean car, always garaged and covered through winter periods. Fully loaded, all options except shaker 1000 (couldn't get with nav)...
I am turning up the boost at the next midnight drag. I still have a stock 2 piece under my car. Up here where I race is a different monster than most of you are familiar with. Our adjusted altitude is often around 7500 ft. At about 20 psi I hope to put down about 760-780 (corrected) RWHP...
Full set of 2010 GT500 seats. 6700 miles on the car. rears out of 2012 car, virtually no miles(from billet pro shop car).
Perfect Condition
(dropped)$2000 shipped obo
For sale are Recaro skins out of a 2012 GT500 with red stripes. I was planning on using these for my car but found some seats instead. Front skins only.
excellent, will post pics tonight.
(price reduced)$550 shipped obo. boxed and ready to ship
I have a takeout Torsen T2 for sale. This is from a 2013 GT500. This is the same Torsen as the '12/13 Boss 302's, and also FRPP M-4204-MB. This unit has less than 500 miles on it, and is like new. It's in perfect condition and functionality. This will fit all 05-14 Mustangs with a reasonably...
does anyone have ARH long tubes, off-road x, and magna flow street series on their shelby?
i have searched and read through lots of older threads/posts, and i can not find any of this exhaust combo. this is the combo i just bought, but it will probably be a couple months before i can swap it...
i have a whipple 2.9 on my shelby and am gearing up for an arh header/complete exhaust install.
here is my plan: i plan on doing this on a lift with a screw jack to raise the engine/trans slightly. i will do 1 side at a time, starting with the pass side. remove the starter, and motor...
i currently have a 100% stock exhaust on my 2010 gt500. i also have an frpp 750hp whipple. i am considering doing an arh longtube set up for a 2011-2012 car so i can run the newer factory (2.75" diameter??)over axle/mufflers and updated hangers.
is there any differences in 02 sensor...
I am looking into a new differential for my 2010 gt500. I love the road course, so I am interested in torque-biasing differentials, but I go to the drag strip on slicks once or twice a year. I have seen t2rs break down there. I talked directly to torsen, and they said that the stock diff in the...
got a screaming deal on some falkins, so i had to buy them. powder coated some 07s and here's what i have...
now i don't have to wear out my 19's on the big course