Recent content by amnpalm

  1. A

    Cobra R rear spoiler/wing

    I have a '97 Cobra and was just thinking about putting on a Cobra R spoiler/wing. Anyone have a picture of this? Does it look good or is it too much?
  2. A

    Backlash

    Have some backlash in the rearend, is there an easy way to take up that slack? It's the stock 3.27 rearend, and Ford rebuild about 2 two years ago for the same problem but now I'm out of warranty and it's my problem. Thinking about pulling it out and putting in a IRS, or should I rebuild it with...
  3. A

    Installing IRS in a '97?

    Have a question for you guys. Found a used IRS from a '01 Cobra and wanted to know can I put this thing into my '97 Cobra. Is it a direct bolt in or do I have to fab up some stuff up to make it work? Any one out there have pic's of this? Final, what should I pay for this thing? Thanks, Matt.
  4. A

    Coilover Advise

    Looking to put on a set of coilovers on the front of my '97 Cobra. I do use the car for autocrossing and do open track events. My question is what brand and what spring rating should i go with? Something not too expensive but not cheap either. Thanks, Matt
  5. A

    Motor Mounts

    Just get finished installing new motor mounts on my '97 Cobra and it feels great to saving over $1200, that's what Ford was going to charge me. Car drive tons better, like new again. Advice to you do it yourselfs, The starter and a pisser, and once you fish out the old mounts the new ones are...
  6. A

    '97 Cobra motor mounts Installed

    Just get finished with installing the new motor mounts on my '97 Cobra. The job took alittle over 6 hours and I did it all myself. Feels great saving more then $1200.00, that's what Ford was going to charge me to install them. The job was pretty straight forward, the hard part was fishing those...
  7. A

    Motor Mounts broken?

    Ok, guys here's the deal. I'm getting a bad vibration at high rpm's around 5000 it starts, and if I jump off the line hard the vibration is here. Took to Ford and they stated that I have broken 2 motor mounts and it will be $1200 to replace both. Told me that they would have to drop the K-member...

Top