Recent content by mustangmike01

Yes I know these engines can take 700 to 800 all day that I have seen on here. I thinki hes playing it save and thinking of engine life and longevity. He said any v8 can make 1000hp but the question is how may pulls will it last before a rod says hello. I ment valve springs. He did say it's...

Hey guys sorry for the delay. I did some pocking around with the fuel system and I was wrong. I have -8 fuel line from the hat to the filter, an adapter from the filter to the oem rail. that's it. no fitting bends either. No return line. Long story short the guy that built the motor installed it...

My setup,keep in mind this was all done back in 06. The setup has 24k on it. Engine has a oem block, stock pan, JE pistons with stock compression, all ARP fasteners were used, Manley rods, used the stock crank that was micro polished chamfered oil holes and balanced to a half a gram. Oem oil...

Well figured it out. Its the inner belt. The water pump it leaking when she's running and leaking onto the crank and rusting it when it site for a couple of days. I'm running the oem pump right now. Anything better out there these days? Seems like edelbrock makes one? Clutch was a stuck...

Need some helping. I have an idea what it could be but I'm hopping it's not. This is what happened and what I have done so fare. I was full out, I was going through the gears, I was in the top of 3rd when i lost all power and so one. The motor was still running. At first I though the motor blow...

I do not have a truck or suv and never will. I do have a house and I do work on it all the time. So I got a wagon to get most items. If I'm doing big projects I have the store deliver it. My wife also has a car and hates suvs also.

Need some info/lesson in what is out there and how to make it work and be cheaper. I do not watch much tv anymore, but my wife dose. She needs her dam shows, a list of channels she needs. cbs, nbc,fox, TLC, discovery, food network, bravo, usa. Right now I have cable and a amazon stick that I...

How this started. Got a new alternator and it's a smaller pulley. My setup 03 cobra, 2.8 rr sc pulley, 4 lb lower, metco 4 piece idlers, alternator 3.5. was using a 81 5/8" belt, no belt problems or slip. just got the j2 alternator that comes with a 3.2 alternator pulley, belt was to lose...

Hey guys like the title say, my dam oem tensioner bearings are going again. They seam to last about 10k. I do not know why I have so many dam problems with these bearings all the time. Is the oem the way to go or should I be running something else? Thanks

Okay, How are the dynomax ultra flows?

Like the title says guys, looking at running the Magnapack mufflers out the side. Right now I have Mac LT and a BBK O/R H pipe with Flowmaster 44 with dumps. I hate the sound. It sounds so muffled, two chambers s*** on these engines.

Whats everybody using these days? The oem lasted me 2 years after my built motor was done back in 2007. I then got the PA Performance 130 Amp Alternator from lethal, it lasted 4 years. I then got an autozone one and it lasted 2 years and my last one was a rebuilt oem. its about 3 years old...

Yep, $275 plus shipping.

whipple still makes it, I talked to them, it will be here next week.

The bolts where tight, I go through the car before I put it away for the winter and I only drove it 600 miles this summer:( I did check all the pulley bolts and there all tight also. It dose have two mounting two. I was lucky it did not come through the hood, it went right to the drivers...