About 1000 miles ago I installed a
Ported blower
Accufab tb/plenum
BA2600
60# injectors
KB BAP
After the retune the car ran great. As of recently, the alternator is starting to go bad and I'm getting low voltage if I start to get on it. When the voltage drops when I'm kind of getting on it...
So recently I just installed a FRPP diff cover and did MM front and rear poly bushings. Last night I was testing my new n2mb wot box and I was doing flat foot shifting when my diff seal blew. I checked it today and 1 bolt is gone, and three are backed out halfway....
I sealed the diff with...
Installed WOT Box and now my car is misfiring at idle and when I rev through RPMs. When car is in the on position, box flashes when gas depressed then stops flashing for a second when I hit clutch. Everything seems to be installed correctly so I'm unsure what it could be. Car drove just fine...
I have a 15x9 with 5.5 backspace and just curious if a 325/50 will fit. I have rolled fenders, IRS bolt. I know the tire is a bit over kill for what I need it for..
Doing a ford racing diff cover install and bushings. I did not do the aluminum diff bushings front or rear. I replaced the stock rear bushing with a new maximum motorsports bushing. They say the cover does not need to be milled to fit with stock bushings.
Attempting to to line up the two rear...
Looking to upgrade my toe links. Couldn't find much about the differences between the two.
Are they both small enough to fit a 15" wheel?
My front diff bushings are worn and needed replaced. I've read that FTBR solid bushings makes a lot of clunks and noises. It also looks like steeda was...
Jokerz Performance Port w/ 2.76 Pulley
Accufab Throttle/Plenum
Intake
Stock Manifolds/Catless X/Borla Stingers
60lbs Injectors
Ba2600
KB BAP
Stock Lower
VMP Dyno Tune on 93 octane
515/502 . Not bad for stock manifolds/lower and 147k miles
https://youtu.be/OoS_zvj2V6c
(unsure how to post the...
All parts were pulled off of my car in 100% working condition. All parts listed were swapped for upgraded parts is the reason for selling.
Stock 03 cobra MAF - 50$ shipped
Coil covers (2 sets) - 60$ shipped a set
Stock hood vents - 50$ shipped
Supercharger/Plenum/ThrottleBody/3.1...
Recently got a single aeroforce gauge installed and had no issues. Then bought a new optima red top battery. About a week and a half later my second aeroforce w/ afr adapter came. Now I have dual aeroforce setup with the afr adapter installed. I'm using a fuse tap into the traction control, and...
Just as title states. Looking for any of these parts in great condition. Will update list whenever I buy a part.
BA-2600 MAF
JLT RAI (gen2)
Located in Orlando, Fl
Looking to buy a set of valve covers. Just bought some cop cover, so no need for them.
I would prefer unpainted but will buy if they are looking for flat black or dark gray
Was trying to find information about the correct size bleeder screws for the 03 cobra front and rear calipers. All the info I found doesn't match eachother.
I got a set at auto zone that was m10x1.0 35mm long but only half of it goes in and stops. I've read that other sizes were 33mm but that...