Recent content by robert presti

The one thing I would add is it seems you can only data log one bank and at the moment ...I have two banks doing something different from each other for some reason. and that is seen on the DLG1 Not a mistake between the two analog outputs.

I went to the site and found the formula. I forgot that there is an LC-2 device as well, not just the gauge. Live Link has a LCI formula that is right for the LC-2. 0 volts is 7.35 and 5 volts is 22.35 (v*3)+7.35 ,or something very close to that. One thing I hate about the innovate wide band...

I like some country but not much. Rebel Son and the Pine B ox Boys are interesting , though not sure what they are classified as. Banjos and steel guitars are neat even to this metal head. If you're into music check out Spotify.

I want to data log my Innovate DLG1 dual wide band o2 gauge. I did recently, but only in a voltage, which means nothing without knowing how to convert it. I'm using live link 2 and when I had a single AEM everything was great (just click AEM), but now not sure which to pic for the conversion...

I guess a reality check on that would be songs now 30 -45 years old for the most part.

I'll be fine ... that was over 20 years ago, though I don't think I got over it until the past 5 years. I don't know most songs unless they are heavy metal or rock and around 20- 30 years old.

My son is dead so I guess I have the luxury of that as well? WTF is your point ? I posted a question about tuning a car in the tuning section.

Some mechanical issues has been changed so now I might not have to worry about a runaway idle. I also have the dashpot set close to as low as possible , because I hate pushing in the clutch and the engine flaring and free revs that take forever to settle back down. I just wasn't sure how rich...

yes I'm trying this myself. Unless I peg the MAF on a wide open pull, I think I have the car set up nice aside from a few tune issues. The biggest thing was getting a big enough recirculating valve for the super charger and locating it before the intercooler.

Built engine with a d1-sc super charger. The engine can run 850 rpm warm, but not if I hit the brake hard, so that's why 1000 rpm idle . The issue starts the second the brake pedal is pressed... Same for my cold stall issue. 13.5 is what I'm seeing on the wide band cold and around 15 warm. The...

I have a car that runs great hot, well after 2-5 minutes . It will stall when braking any time before that. A 2000 mustang GT and I'm thinking the hydro boost brakes create just enough draw on the power steering pump to stall the engine. I don't believe this car has a switch to add rpm for that...

So after changing the pipes and location of the recirculating/ blow off valve to pre intercooler I now have a MAF add count variation of around 10 max. Going back to the start we see 100 max. Could a real tuner have made this car run good with the mechanical short comings in the set up? I don't...

I did so me research on that and many thought having it after would be better for power. And what made sense there was probably killing my drivability There might be a slight edge in all out racing having the blow off valve after the intercooler, but in my opinion and experience no gain would...

That's where mine is and it is fun at times and at others not with a stick shift. I have to go way out of my way to keep it quiet and it is a sound here people aren't used to.

My car has been through more plugs than should be needed. It isn't easy to change them either. Not the end of the world as far as hard but it involves removing the fuel rails and the mess that comes with that. I have run the NGK tr6 not sure what else and I don't like them. These copper core...