Recent content by tonydahose

  1. tonydahose

    Hi. I read that you make the USA flag bumper letters. Are you still doing that? Thx

    Hi. I read that you make the USA flag bumper letters. Are you still doing that? Thx
  2. tonydahose

    Has anyone made a gated shifter plate?

    i have always liked the look of those. thanks
  3. tonydahose

    FS PRO5.0 shifter and C&L maf/K&N filter

    i was cleaning out my garage and i have no use for these anymore. I only had about 18K miles on my old cobra 1999 so there isn't that much use on any of these parts. First up is the shifter, $100 + shipping, whatever it is. Next up is the C & L mass air flow meter housing with a K&N filter...
  4. tonydahose

    Simple trunk light mod

    i did a search and didnt see anything but i might have missed it so if this is a repost mods can delete it or everybody else can ignore it till it gets off the 1st page. The light in my vert is crappy at best. i tried a led bulb and it was a little better but not much for the back of the trunk...
  5. tonydahose

    Will a pro 5.0 shifter from a 99 cobra fit into a 03?

    my old 99 vert got totaled last summer. i took out the pro 5.0 and i want to know if it will fit into the 03 cobra that i just bought. i emailed the pro 5.0 guys and they said they "think it should" if it doesnt that is fine, i will just sell it and buy a mgw shifter. has anyone done this swap...
  6. tonydahose

    carfax someone

    looking at trading in my beater for this first thing tomorrow morning...appreciate any help i can get 1GNFK16Z82J137370 2002 chevy suburban
  7. tonydahose

    can someone run a carfzx for me..thx

    looking at trading in my beater for this first thing tomorrow morning...appreciate any help i can get 1GNFK16Z82J137370 2002 chevy suburban
  8. tonydahose

    finally finished the stereo install..some pics.."dial up warning"

    heres the head unit the old cd player slot..i have a cord hooked up to the radio so i can have my ipod play through the aux. port heres the sub and amps..boston 10.5' and phoenix gold 450 and 250 amp..i still have to clean up the wires a bit and last but not least a pic of my shifter
  9. tonydahose

    new toy for the mustang

    won it on ebay yesterday..10.5' sub
  10. tonydahose

    cylinder slap?

    you guys get this at all...i just started hearing it...maybe i wasn't paying attention to it b4 ...a guy i spoke with said it is common on the 4.6's until the car warms up and then the piston or the cylinder expands as they warm up and it stops...i have heard it sounds alot worse on the...
  11. tonydahose

    cylinder slap?

    you guys get this at all...i just started hearing it...maybe i wasn't paying attention to it b4:shrug: ...a guy i spoke with said it is common on the 4.6's until the car warms up and then the piston or the cylinder expands as they warm up and it stops...i have heard it sounds alot worse on the...
  12. tonydahose

    finally...12's

    fisrt post in this part of SVT... 60' - 1.755 330' - 5.309 1/8 [email protected] 1000' - ???reads .000 1/4 - [email protected] that was the 35th run on the stock IRS...next run kaboom half shaft...lol...sh1t happens
  13. tonydahose

    got my 12's...half shaft went kaput soon after

    well hot as hell here 90 degrees...not the best for times but on the 3rd run got my 12 sec...4th run kaput on the drivers side half shaft....i was very pissed off...wheel hopped like once and then it was over...track was really hooking up...when i got out of the car my feet were sticking to the...
  14. tonydahose

    stock crank bolt for the pulley

    does anybody out there still have it???? the one with the big azz washer on it...i am selling my t/a and i dont have the original bolt...ford say they are on back order and dont know when they will get them

Top