Recent content by UncleSAm

I have the single with the steering wheel set up that I’m about to pull off in a couple days

I’m debating if I should go or just be a spectator

Oh ****! Big daddy’s back!

With time and money, it's possible but I don't see where there is much room on the front end

So anyone wanna make me a set? Haha

My man! Hehehe

900 for the whole set? Have a link for the headlights

Deposit sent

Put me down on the list, thank you sir

1. Should have only taking like .050 off. 2. Should have messaged me cause we’re local. 3. Don’t trip cause I have had the aero catch for years now and no issues. Mines from the first batch as well

most cost-effective and easiest way it to sand it down a little and keep everything the same

No you need both cause there’s a latch on both sides, only thing you can realistically do and the cheapest and easiest route is to just sand down the front so the front plate sits flat without a gap. We’re not talking a lot of sanding took me 5 min or less to sand it

If you did that, 100% would you loose the hood on the freeway. That is if it even makes it though closing the hood with out destroying. where the latch comes in contact. There’s a reason why the factory had metal not fiberglass there. Sanding it is the only way to close the gap and not have to...

You’ll notice the gap between the out side plate and the fiberglass cause when they did the mold the factory had the steal part for the latch blah blah blah.. anyways it didn’t turned out to be so flat. So I sanded the surrounding area down to be flush so I wouldn’t need a filler piece because...

Problems not with the latch kit it’s with the mold