Vortech V1 T-trim $1800

turbocooker

Member
Established Member
Joined
Aug 6, 2011
Messages
60
Location
kirkland
This is not a 100% bolt in kit. It was on my race car with tube front end and had custom piping. The supercharger comes with the following:

*V1 T-trim head unit with bracket
*Misc intercooler piping and couplings
*Intercooler with cooling fans
*BOV and wastegate
*RR 9lb 6rib pulley
*(3) Vortech T-Rex fuel pumps
*Oil feed line and drain
*Large air filter

I might have a belt for the stock bracket also.
IMG_20161121_153201054_HDR.jpg
IMG_20161121_153217588_HDR.jpg
IMG_20161121_153310118_HDR.jpg
IMG_20161121_153332725.jpg
IMG_20161121_154224243_HDR.jpg
IMG_20161121_154245667_HDR.jpg
IMG_20161121_154431667.jpg


I also have a custom COG belt setup that I built that I can sell. This can't be run on a car with the radiator in the factory location. I can include this setup for an extra $700. Comes with Bracket, blower pulley, crank pulley, Innovators West damper, 2 belts and idler pulleys. This pulley setup will make over 20lbs of boost.
 

Attachments

  • IMG_20170119_185606157.jpg
    IMG_20170119_185606157.jpg
    370.1 KB · Views: 238

old01cobra

Active Member
Established Member
Joined
Aug 27, 2012
Messages
257
Location
IL
Nice setup you had.

How's the condition of the blower?

When you were running 20lbs what was it making and what was done too the engine? Asking because I have a BB/S with all the supporting mods. Trying to get an Idea what it would make.

Your brackets will they fit a 01 cobra timing cover? I have the Fr500 intake with the 98 top plate so the tubing might actually line up somewhat.
 
Last edited:

turbocooker

Member
Established Member
Joined
Aug 6, 2011
Messages
60
Location
kirkland
Nice setup you had.

How's the condition of the blower?

When you were running 20lbs what was it making and what was done too the engine? Asking because I have a BB/S with all the supporting mods. Trying to get an Idea what it would make.

Your brackets will they fit a 01 cobra timing cover? I have the Fr500 intake with the 98 top plate so the tubing might actually line up somewhat.
Brackets should fit an 01. I never ran the car at 20lbs. I was using a waste gate to bleed off boost. The blower is in good working condition.
 

Users who are viewing this thread



Top