Any strut tower brace fit over the 2.9 Whipple?

Hi all....

Recently purchased a GEN 4 Whipple. Thinking about adding a strut tower brace to fit over this bad boy? Anyone know or have have one that’s doing the job currently?


Sent from my iPhone using the svtperformance.com mobile app

Thats a good question. I would assume so. Maybe Kenny brown

MMSTB-8 should work.

Kenny Brown works too me thinks but it mounts under the CC plates which is kinda lame.

according to whipple the new gen 4 2.9 is the same height as the 2.3, i asked for this very reason. i have a 2.3 tvs now and the mmstb-8 clears with lots of room. it also cleared my 2.3 whipple i had previously. the only thing i can see being an issue is with the crusher inlet by the strut tower, the height should be fine though.

Confirmed that the MM brace does clear the blower but the crusher intake is a different story. Its fits but it is very very close so I may clearance the stb little to allow some movement

Stifflers makes one for the 2.9L Whipple. They created it off my car. It has a JLT high boost. My whipple is a Gen 2.