KB mammoth need to clean injectors,how??

Danimal95

New Member
Established Member
Joined
Oct 16, 2018
Messages
14
Location
Il
03 cobra motor and trans swapped 03 Mach 1 with a 3.6 KB mammoth blower. Bought motor and trans used with the blower already installed so I have no experience on installing it,dropped old K member removed stock Mach motor and bolted on termi..that’s the long and short of it.

looks like a nightmare to remove injectors,but a failed fuel filter leaves me no choice. It appears that the intake plenum has to be removed to get at the rear drivers rail bolt and injector? It also appears that to remove plenum there are 4 bolts from the rear securing it,which look like to get at the lower drivers bolt the motor will need to be dropped? Is that correct or am I missing something? Thanks in advance
 

Danimal95

New Member
Established Member
Joined
Oct 16, 2018
Messages
14
Location
Il
Sorry mis-spoke I think it’s a 2.8,with the mammoth elbow..I need to run the serial numbers again
 

03' White Snake

Well-Known Member
Established Member
Joined
Feb 5, 2007
Messages
3,792
Location
Mass
Pull the blower. I am swapping injectors on my 2.8h soon. I remove all the intake manifold bolts, stand on the 2 strut towers and lift the blower. Stick a 2x4 under it to hold it up. Swap or clean injectors and put it back together. You might be able to do the passenger side first without touching the blower.
 

Danimal95

New Member
Established Member
Joined
Oct 16, 2018
Messages
14
Location
Il
Pull the blower. I am swapping injectors on my 2.8h soon. I remove all the intake manifold bolts, stand on the 2 strut towers and lift the blower. Stick a 2x4 under it to hold it up. Swap or clean injectors and put it back together. You might be able to do the passenger side first without touching the blower.
 

Danimal95

New Member
Established Member
Joined
Oct 16, 2018
Messages
14
Location
Il
It looks as though the rear bolt on the drivers side is nearly impossible to get to,am I looking at it wrong?ir does it take a swivel socket or special tool?
 

Danimal95

New Member
Established Member
Joined
Oct 16, 2018
Messages
14
Location
Il
Ok so I was way,way over thinking this,could not have been easier...took longer to get all the induction and TB removed than to remove the blower...thanks for the advice
 

GodStang

Well-Known Member
Established Member
Joined
Aug 20, 2003
Messages
14,719
Location
Aiken, SC
I have the 3.6L and you just remove the TB, CAI, the 6 bolts holding blower to platform and pull blower. Remove 4 fuel rail bolts and replace injectors and put back on and install blower and CAI.

A3A43492-2FE3-4DA1-81D0-02BD11D582FC.jpeg
 

Users who are viewing this thread



Top