Separate names with a comma.
Bump I know there is one out there somewhere
Still looking
WTB / ISO 2004 Mystichrome Coupe preferably low miles but I care more about condition then miles. Willing to spend up to $35,000 for the right...
i am pulling my hair out at this point. I worked on this for a few days at the end of last season and had to put the car into storage unrepaired....
Hotcobra I think you misunderstood me everything on pin 24 of the CCRM checked out as you described. I am seeing / hearing the beeps clipped to...
I have those two fuses out as you told me. I am not understanding your last message, what should I be doing next?
Hotcobra, I disconnected the CCRM, both C133 & C1045, the MAF, IAT, both connectors under the air box, and pulled both fuses 2 and 8 for engine...
Dave, I tested the PCM connector and pins 3,25, and 51 all show good grounds. Pin 55 has 12v all times as it should.
Hotcobra when C133 is disconnected the fuse still blows, and when C1045 is disconnected the fuse also still blows. Not sure what to look at...
Hotcobra, I will check those two connectors when I get back home. The only part I am not sure of is that when you unplug those connectors aren’t...
Hotcobra with fuse 2 and 8 out the fuse still blows and the circuit tester still shows “short to ground”. It does not matter if both are out or...
With the CCRM out and a new fuse installed the fuse does not blow if the key is turned to run and the circuit tester shows that it is an open...
Jay took the CCRM out and 8/10 are shorted together out of the car and are open to pin 24 once 12v is applied to 13 and ground to 18 the relay...
I will check all of the above when I get home, Dave are you referring to the noise supressors or a braided ground line? [IMG] The things I...
I have both noise supressors unplugged and have verified they are not grounded out. I will check pin 55 of the PCM for voltage as well as...
It is for sure the F26 PCM fuse and as mentioned before even with the suppressors unplugged it is still blowing indicating they are not the problem.
I have unplugged both noise suppressors in the fuse still blows immediately upon turning the key to on.
Sorry I made a mistake in my original post. It is the F1 26 fuse the 30 amp PCM not a 40.
They are radio interference suppressors . They have voltage running through them and cannot be grounded or they will blow a fuse. They can be...
i am pulling my hair out at this point. I took the car to the drag strip made my first pas and the car completely shut down around the 1000’...
Just finished installing my Mantic clutch in my cobra along with a T-56 Magnum from D&D performance. Question I have is what pivot ball is...
I am in the process of installing my Mantic clutch and am struggling with understanding where the tob should be in relation to the fingers on the...
Is the part number anywhere on the clutch itself? The only part number I see is a sticker on the case with the part number handwritten on it....
Question for those who have bought a Mantic Clutch for their 03/04 cobra. Did they include the mechanical throwout (release bearing)? I got my...
Does this not apply to the mantic clutches? I tried and it says Coupon code "dad" is not valid.
