Separate names with a comma.
I used the LMR chart. I have a 4lb lower with a 3 inch upper and a 3.2 inch alt pulley. I removed a motoblue 4 pulley kit and replaced with a UPR...
Well I just installed a Gates fleet hd belt. (The green one) Boy did I have to stretch it on. Anyway the noise is gone again. Have to wait and see...
I have a video but it won’t upload
I flipped it and the noise came back. Took a few days though. And that’s why I can’t track it down. Anytime I touch something the noise doesn’t...
The clutch and tob are a year old. I also did a steel retainer while it was out. I thought it was the tob originally because when you touch the...
I can’t get the video to load. Damn it
It won’t load
Every pulley on the front of this car is new. I installed the new double bearing idlers today. Started it up and within two minutes I get this:
Ok so the noise is back. Except now it doesn’t do it on startup when cold. Now it waits till the motor has some heat then comes out to play. I...
I ordered the same kit. Looks good
Ok. I flipped the belt. Had a hard time getting it off the alt pulley so I removed the two lower idlers. I just happened to turn over one of the...
I have a aftermarket alternator. Installed it in 2015
I’ll try the flip and see what happens. I don’t think it’s the inner belt because when the noise started that was the first thing I changed along...
Oh well. Guess I haven’t found the problem. After 5 days the noise is back. Chirp chirp chirp
How much are the kits?
I’m actually guessing that it’s not one of my pullies. I swapped out the stock ones years ago with a moto blue set. But this year the car started...
Looks like I’m gonna need a new set of idler pullies on my 03. Been looking at the4 pulley set from LFP. Anyone here ever use them? Any opinions ?
How much boost should it make with a 3.5 pulley?
Without removing anything else, if I just unbolt the drivers valve cover how much room is there underneath? Stupid me was working on the car...
The system takes about 5 min to fully balance out. When I changed the orifice and accumulator I used a a/c flush on the evaporator (reverse flow)...
At anything higher than idle it just cycles a little faster
With static pressure it get about 1 psi to 1 deg outside temp. When I did this it was 85* out and I had about 83psi high and low sides. When...
Orifice was changed. The thing that gets me is where did this clog come from? I’ve owned this car for 11 years and never had a problem with the...
After doing a new liquid line and orifice valve my a/c still didn’t work right. The high pressure side would spike and suck down the low pressure...
CJ pony parts, FTB, autozone, pep boys and advance all listed them as either sold out or no longer available
