Search results

  1. mhunsr

    Timing Chain Noise

    Was out driving around on Saturday and started hearing a constant ticking/rattling noise. I had to stop somewhere, when I got back in the car and started it, the noise started again after a few seconds. When I arrived at the house, popped the hood and it is definitely from the front of the...
  2. mhunsr

    Charlotte - 55th Mustang Celebration

    Anyone else going to Charlotte next week for the 55th Mustang Celebration? I will be on the ROVAL Thursday. Just wanted to know who else might be there.
  3. mhunsr

    15-17 Ecoboost MBRP SS race series catback f/s

    For sale is an MBRP race series stainless steel catback for an ecoboost Mustang. This was on my sons car before we traded it and sounds great. $550 plus shipping. Willing to travel some to deliver. Will install locally for $600. My understanding is this does not fit convertibles. Make sure...
  4. mhunsr

    FS: SLP Loudmouths

    Sale Pending SLP Loudmouths on car for 20000 miles. Went to offroad H-pipe and changed axlebacks. Pretty clean with a few small scratches. Not noticeable when on car. fits 05-10 GTs and GT500s $200.00 shipped
  5. mhunsr

    QA1 Adj Struts and Caster/Camber Plates F/S

    Still available and need these gone. This is a heck of deal! I am selling QA1 18way single adjustable front struts and the caster camber plates. You will need the coil over kit and springs to install.. I have not installed these on my car, though the plates were installed on another car...
  6. mhunsr

    Help with 86 GT

    I have an 86 GT with a problem I can't figure out. It surges at idle unless I set the idle at 1000 rpm. At this rpm it runs smooth and doesn't miss or display any other problems. I can rev the engine and not have any issues. I start driving the car and it will shutoff and then immediately...
  7. mhunsr

    Fidanza flywheel question

    Is anyone running a Fidanza aluminum flywheel in a GT500? I am replacing the clutch in my 07 GT500 and looking at the Fidanza for cost and it is rebuildable. I am replacing the clutch with the McLeod RST. Any thoughts? Advise?
  8. mhunsr

    Fidanza flywheel for the GT500

    Is anyone running a Fidanza aluminum flywheel in a GT500? I am replacing the clutch in my 07 GT500 and looking at the Fidanza for cost and it is rebuildable. I am replacing the clutch with the McLeod RST. Any thoughts? Advise?
  9. mhunsr

    Strut Mount information

    Anyone know where I can get a used strut mount? I installed springs this weekend and one of the strut to body bolts snapped off. I was using a torque wrench and all the others tightened with no issues. I have seen them new, but if I want to see if I can get a used one first. I posted a WTB...
  10. mhunsr

    WTB-GT500 Strut Mounts

    Replaced my springs and one of the bolts on the strut mount broke. I need a replacement for a 2007 GT500 with 25,000 miles or less. PM me with the information Thanks
  11. mhunsr

    WARNING!!!! Check your valve stems!!!!

    The low tire pressure warning turned on when I was cruising down the highway. I found my left rear was going flat. I looked for screws, nails, holes or anything else wrong with the tire. :shrug: I had been driving on the highway for about 1 1/2 hours so I figured I picked something up...
  12. mhunsr

    A few pics

    I finally posted a few pics of my car. I usually just wander around and read the threads, but decided to show what I have today. The underhood pic is the most recent.
  13. mhunsr

    Carolina Dragway

    Does anyone know if there is going to be another track day at Carolina Dragway in Jackson, SC?

Top