Thanks for the summary! Looking at the setup it looks like I will have to unbolt the coolant reservoirs to make room to access the pulley tensioners at the bottom of the engine. Does that make sense? Also any info on the torque specs for the blower bolts when I go to reinstalll?
Thanks...
Yup, searched the web and found a few install articles and commentary videos but nothing detailed enough to help. Will try to give KB a call to see if they can share a pdf of the install manual. Hopefully I will get lucky.....
GT
I have a 2007 GT500 with a 2.8KB installed. Bought the vehicle this way many years back. Went to start the car the other day and all it would do is crank but not fire. A few moments later I started to smell gas. Looked under the hood and on the pasenger side bank I had fuel coming out of one...
As an FYI, the Ford cover for the 2010-2014 has the radio antenna sock in the rear passenger side whereas 07-09 antennas are on the passenger front. For this cover to fit right you would either need to remove the antenna each time you put the cover in or cut a hole in the cover to slide over...
The only way to be sure is to take a look at the certificate of analysis for the two drums. There are different levels of purity. At a minimum if you choose to go with the material from the black drum filter it through some high quality paint filters to make sure you don’t get any debris from...
Black barrel is industrial grade. Same base material but will contain some contaminants. The blue barrel is labeled for racing purposes and will be a higher purity. I would be careful with using the black barrel material in your car.
GT
I have a 2010 hood from a gt in ok shape. It’s red. Located in South Florida. Would love to get rid of it.
Let me know if interested. I can send pics if you shoot me your email.
GT
I think Quantum Performance was the Shelby Authorized Mod Shop in Dallas. They did a few upfits (40th’s and SuperSnake’s) along with Tasca in Rhode Island before they went belly up. They over extended themselves and the builds towards the end suffered. They went bankrupt and before Shelby...
Also of note was the floor mats that they had in the trunk. Driver’s side mat was heavily worn with heal imprints (right and left heal). With less then 2000 miles on the car the wear looked excessive and made us think the car was tracked some bit and maybe backed into a wall on the track.
Quick note....saw this car also and thought deal was too good. Ran the CarFax on the VIN and found it had been rear ended. Did some more looking and found that the rear bumper was replaced and right fender crumpled and section replaced. Left fender reworked. Back end of car repainted and...
I didn’t do my whole car but just the hood to get some contrast. However I went with the spray on / peel off wrap done by a local company. I went this route after I saw a couple of cars they did. I think it finishes better then the regular wrap and is more cost effective, especially if you...
The original 2007-2009 GT500 brace first under the 2010-2012 hood and clears the supercharger. Many have gone that route. Is it necessary for street driving...probably not but if you do track the car on a road course it does make a difference. Helps with body flex and turn in under heavy...
The Exedy Lightweight Steel - 6 bolt flywheel weighs about 16.1lbs and the stock weighs in at about 23lbs. 05-10 GT's use a 6 bolt flywheel while the 07-14 GT500 and 11-14 GT's have an 8 bolt flywheel. I'm hoping to be able to reuse my Exedy vs getting a new one.
GT
I got hold of a TR6060 from a wrecked (front end side swipe) 2013 GT500 for a great price. It was from a Track Pack car so it also came with the cooling assembly. I searched but could not find too much information on swapping in a 2013/2014 TR6060 Track Pack into a 2005-2010. I have most of...
You may have to swap the airbags over to the boss seats or purchase the resistors and forego the airbags. I did a similar swap with 2012 seats into a 2010. Everything plugged up fine but like you I got the warning lights. I ended up swapping the airbags and the passenger seat bladder from the...
The GT wheel from 07-09 will fit the GT500 from 07-09 and the swap is pretty easy. If you look around on the web you’ll find instructions. However if you spend some time you can find the factory original wheel although a bit pricy. I think Blue Oval still had some inventory or at least they...