Search results

J2 Fabrication now has a preorder up for the new GT500 crank support. I am thinking about ordering one for my 2013. It is probably overkill at this time as I only have a Gen3 VMP but I may upgrade in the future as blower tech. advances and it sure cant hurt. Any input?

How old are the tires? Date code. Thanks

Still for sale?

No, I'm in North Augusta down next to Georgia. If your down this way or I'm ever up your way ill look you up. Mustang week?

Thanks Jay. I got what I was hoping for. Mods are close to yours: VMP gen 3, 10% lower/2.4 upper, DD149, ID 1300, Fore fuel system, Kooks headers/O/R h pipe, MPR's comp. cams.

Went to Pro Dyno for a dyno session. 1027 rwph on e85 is a good Christmas gift! Happy new year all!

Sorry to hear! Glad you and your family are OK. That's the important think. Like everyone is saying there are more than a few very nice GT500 out there for sale. Hope insurance treats you right.

Are you guys telling me I'm going to have to pull my sleeved block out and put the spray liner block back in order to have a 13 GT500 again. I mean i did loose 4 cubic inches but sh__, I didn't know I changed the hole car!

PM returned.

Brand new Vmp throttle body. Fits GT500/GT 05-14. Only opened box to verify correct parts. Going nomoblade is the reason for sale. My loss your gain! Thanks guys! SOLD

Ok thanks for sharing. Just curious as I have a lot of n2o parts not being used at the moment! Call me crazy be it would be cost effective, if there is such a thing with this hobby.

J, I am waiting to see how much the cutouts help. I may do the same thing in the future. Who installed the spray bar in the lower for you? Thanks, Ken

. Unless you have racing goals, or are just plain crazy :), the torque from a 5.8/TVS2650 is more than enough for any street car. Rolling into the car at 3500-4000rpm from a 3rd gear highway roll is violent—and crazy good fun! Congrats J! Bad ass times. Your car looks and runs great. I...

What a shame. They are great looking wheels. I had already sent my factory wheels to be widened when I saw these. Looks like I got lucky. Good luck with yours and thanks for posting!

You must have the patience of Jobe. The driver side install is tight!

I like it! Where did you buy the LED strip from? Thanks

Lund is doing the tuning. So far it has not went into fail safe mode but I only have 200 or 300 hundred miles. Tip in and drivability is not the best. I am still working with Lund and hopefully they can improve it some.

Im in the same boat. Gen3 and 160. I have not even completed the tuning yet. I have a built motor but I will not upgrade to the R. Between the throttle body bolt pattern and the problems tuning it, I have a bit of a bad taste in my mouth right now!

YES!

Thanks for checking GT350R. The search continues!

Can u check and see if it is a blank 5.8 plate? Thanks

Thanks, but I am looking for a blank (unsigned) 5.8 plate.

Like the title says. At one time they were some for sale on ebay, but I can not find them anymore. Thanks

Salesmen being salesmen! Not surprised. They are nice cars but 98,000 is a lot of coin in MHO!