I have been running E40 (93 octane and E85 mix) in my SRT for a while and also with the 335i bmw of my wife's. The gt500 is just sitting there as I play with these and I think its feeling left out. I had good results with the SRT but amazing results with the 335i b/c of it being turbo. Anybody...
I swapped both of my cars to 0-40 Amsoil last week and had a temp rise on avg of 4 degrees all the time on the srt8. It's my dd and I always monitor all my temps on the drive in to work. (30 mins)
I have no way to check the gt500 but I am guessing I got the same with it. Any thoughts on this.
Installed a 10% lower with my 2.4 upper about 2 weeks ago and blower whine is crazy. :):):):):):):):) Even driving normal you can hear the supercharger. I guess because I'm spinning it at about 20,000 rpm or whatever but I am ready if something fails.
I feel like I'm driving a GN or typhoon...
Played around with a 15 gt mustang on the highway for what must have been 60 minutes or so. Finally it opened up and I get to wipe the Dracula stare I got from him off his I'm so cool face.
I eased up beside him ready for a "supra roll race" going about 85 with wide open road ahead. He does...
I just installed a optima yellowtop battery and left the stock blanket/cover whatever the heck it is off. I think it looks better with it so is there any aftermarket choices or options? My stock one is dirty looking and shows up more with this aftermarket battery. My car is a 2011.
Just ordered a new valve for my 11 gt500 because mine leaks. Got the new one and it leaks just the same. Which means I'm pulling a lot of oil vapor from the valve cover all the time. This is the passenger side port which is after the tb. Now why would ford want this?
This explains why we get...
Lately I have noticed what looks to be a blue puff of smoke on cold start. I always notice oil laying in the supercharger elbow and normally wipe it out but its been a while. Has anyone replaced the pcv valve on these, mine has 24,000 miles? I use a jlt separtor but it doesn't get it all...
I have bmr lowers and I want to go with something softer, hence the roush lowers. Mine have 5,000 miles and I will include some money if somebody want something stiffer.
https://www.youtube.com/watch?v=RUww__S5W7Q&feature=youtu.be
Unfortunately this was my only clean run but I will add the others when they upload. You can see how the car was moving on top end with the wind and the loose track. Scary I should have lifted.
Speed was 148.9
Mods 2011 svtpp...
Installed the aftermarket gauge and it is way different than the stock like I was told.
I have a 2.4 upper with a ported blower making 13 1/2-14 psi at 6300.
So after installing uca and lca's the whine is just out of control. It has me thinking of changing the oil again. I feel as though the noise is getting louder and maybe the royal purple gear oil has sheared. I get no noise when cold but after about 10 min's it is whining louder than my 6 year...
I switched from stock to the Mobil one atf about 5,000 miles ago noticed a nice difference on how smooth it shifted after. Now as it gets cold the trans is not liking a shift in to second gear cold. My new oil showed up today and hopefully I will see a change tomorrow. I will update after it's done.
Ok I have been down the track 5 times and it has grinded and or locked out every time. My car doesn't have any other problems even on the street. I am looking for the car that always had problems and is now fixed with this shifter. I could just take it to the dealer but I would rather go this...
Previous was
1.94
7.92
95.46
11.98
122.62
this was a hot lap to this
1.93
8.11
96.59
12.10
124.69
both of these were on 2953520 mpss
New runs are on nt05 3153520 along with a off road x pipe and home ported eaton.
2.02
7.66
98.81
11.60
126.33
This was leaving off idle with a small bog but I...
Ok guys I am posting this over here b/c I see more traffic in the 13/14 then the older gt500 section. What care needs to take place to make sure this event is successful for our gt500's.
Gas? Tire pressure? Air dam removal or adjustment? Is the street tune safe, should I lower the timing? Ice...
I have searched and it seems some say it is normal but I wanted some of your input. I am using the stock gauge but it is always constant 15 psi from 3500 rpm on. I got the ported blower on and now I have 14 psi and then it climbs around 3500-4000 and just maxes out the gauge. It has never done...
Mine told me last night the gear whine needs fixed and the tires spin to much which is just dangerous. "I need to take it to the dealer". Other than that she loves it. Haha
I explained the warranty covers the gear whine but not the spinning! Now I have the ok for dr's though.
This is the first time I have taken it to the track since I bought it. I lowered the psi to 21 and let it rip or spin you could say. Best 60' was 1.93 out of three runs but I could never go wot in first or shift hard into second w/o it blowing off the tires. First run 12.1 @ 124 with a 1.93 60'...
I have read so many post on this and still I find myself questioning my set points. Driveshaft pointing down in rear so this is negative and my setting is -3.5. The rear end pinion is pointing down so this is also negative and my set point is -1.5. The car is a 11 gt500 stock ds with lca's and...
I started the porting process on the tb and wanted to included some pictures for all. So far so good my objective is to knife edge all restrictions on the inlet of the tb and smooth the ribbed machining...