Ok so my car is lowered and at upper speeds it gets pretty sketchy like the front end is dancing all over the place. I recently bought and had installed j&m caster camber plates. Install went great, I had the car aligned and had the tires balanced but the car is still shaking at high speeds 120...
My 2011 shelby is lowered and is having bad toe out meaning the insides of the front tires are wearing. I was wondering what brand of camber plates are my fellow lowered shelby brethren are using. Any feedback would be appreciated
I posted a while back when I raced an m4 when I was stock since than I had a 2.5 pulley, intake, and exhaust with a dyno tune installed from archangel. I couldn't have been happier with the results I'm putting 550 hp and 570 tq to the wheels. Anyways on to the races....
Race 1 vs 2014 zl1 auto...
So I have a 2011 gt500 and I will be putting a jlt big air intake with off road x pipe and 3 inch MagnaFlow exhaust with a custom dyno tune next saturday. What kind of power gain should I expect from this?
So I was cruising around town in my stock 2011 gt500, pulled up to a red light and some BMW pulled right up behind me. Light turns green I do a half throttle pull and the BMW is on my ass, so I gun it and pull away a little. The BMW gets in the left lane and does a fly by, that's when I notice...
I have a 2011 gt500 engine that ran lean and melted the piston in cylinder 8 so it would need sleeved. However the engine still ran just misfired and was low on compression on cylinder 8 about 15 %. Heads should be good. It's a complete engine from the supercharger to the old pan. I can send...
So I have a 2011 gt500 I had the original motor replaced with a stock low milage motor. The replacement motor had about 10000 miles on it and I managed to put 2000 on the new motor before my car started running extremely rich. And I got the fuel pressure code. I looked at the sensor in the trunk...
Ok long story short I bought my 2011 gt500 full bolt ons supercharger swap with MagnaFlow xpipe cat less exhaust setup. The motor blew up, I put a completely stock one back in but exhaust setup is the same. Do I need a tune for my exhaust or is it fine? Any input is appreciated greatly.
I have the 5.4 aluminum engine with low compression in cylinder 8 the top of the piston is pitted and they cylinder wall is scorred. It happened due to the engine running lean however the engine still runs and drives. I actually drove 40 miles to my house like that and it still pulls really...
I have a 2011 gt500 with 12000 miles on it. After the third day of driving it it started misfiring, I took it to a local performance shop. They did a compression test and cylinder 8 failed. They checked my pistons with the little camera and a chunk of my piston in cylinder 8 is gone. I don't...
I just bought a 2011 gt500. I drove it three days and it misfired and the compression in cylinder 8 failed. The performance shop I took it to used that camera thing to look at my pistons and I'm missing a chunk out of cylinder 8. The cost for an aluminum block is crazy so is it possible to...