Hello,
Looking for advice to finally put together a short block. I have been acquiring parts for a long time now for an all out Aluminator block build, but figured before I go building a high dollar engine, it would be best to cut my teeth on something more budget friendly to avoid the...
Hey everyone,
Not an engine building expert so wanted to ask some advice. Doing a budget build and have some random parts
I've got a cobra iron block that needs to go to 0.0020/30 over. I was wanting to do a higher compression N/A build, possibly low boost in the future. Using h beam rods...
Title says it all. Let me know what you have. Does NOT need to be complete. Does not need to be ready to go. All I need is a good core with no spun journals, don't even need cams.
Located in raleigh, nc
Thanks!
Sent from my SM-G975U using Tapatalk
I have a set of 4v heads and the only cams I have right now is a set out of an 05 aviator. Looking to see what the best option is for an upgrade using ford parts. Using a stock m112 blower and compression around 9.5:1
Would stock gt500 cams be the best bet? I'm no expert on cams. Guessing I'm...
Hey guys,
Putting together a budget friendly rotating assembly for a mild performance build. Have a Kellog crank, set of stock cobra rods, just looking for a good set of forged pistons. No plans to run crazy boost or anything like that. Looking to run 9+:1 CR.
Any good reccomendations for...
So I picked up a low mile cobra engine that was rebuilt with the cheapest Taiwan special pistons I've ever seen. It had melted 2 pistons and blew a small hole through both of them. When the piston blew through, it deposited a small amount of melted piston on 2 of the rods as you can see in the...
I have a chance to snag a low mile 04 cobra short block for cheap. Problem is 1 piston leaned out and melted the top ring land a bit. Could this cause damage to the rods/crank?
Thanks!
Sent from my SM-G975U using Tapatalk
I am in need of 1 passenger side exhaust manifold from 99 cobra. Afaik 99 to 04 should work, but if you have a 99 let me know.
Thanks! Rob
Sent from my SM-G975U using Tapatalk
Looking for an aftermarket ignition for my motor. Im running an 04 cobra motor that's going to be swapped into a crown vic. Been debating on what aftermarket ecu to go with, the MS3 looking great with the whole dash control/plug and play aspect which could make things a bit easier. But everyone...
Hello all,
I'm building a high boost ford racing boss 5.0 stroker with 2v TFS heads but can't find gaskets for this application. Could someone point me in the right direction? Thanks :)
Hello all,
I'm building a high boost/high compression boss 5.0 stroker with 2v TFS heads but can't find gaskets for this application. Could someone point me in the right direction? Thanks :)
Heres a link to the block: http://fordperformanceracingparts.com/parts/part_details.asp?PartKeyField=9778