Search results

  1. Jvibe92

    Car Cuts Off At Idle Intermittantly

    Chasing an issue for too long now. Need some input. Car has been running fine but intermittently cutting off at idle, in which it’ll fail to restart in two attempts then start right up on its own on the third. Before it dies, the Idle starts to become rough, Rpms drop under 500 then it’ll cut...
  2. Jvibe92

    MAF shorted and got wet in rain storm. Do I need a retune when putting in a new one?

    As the title says. Left my cobra jet setup outdoor and got rained on for two days. Went to start it and barely ran and died. Code was for MAF sensor. Checked the MAF and was damp with water residue and tubing was wet. About to head to an autozone and get a MAF sensor. Do you think it's a direct...
  3. Jvibe92

    One month storage with E85 question

    So what was supposed to be 2 weeks of my 5.0 sitting in my garage turned to a month and a couple days. I've started reading that with more than a month of storage required a few things (battery tender and fuel stabilizer). I run full E85 and I actually already had about 80-90% tank full. The car...
  4. Jvibe92

    For Sale: TPMS transmitter tool

    Sells for $46.97 from AmericanMuscle. Never ended up using it. Looking to get 40 shipped or best offer. Works for all 07-17 cars 281-620-5853 Sent from my iPhone using the svtperformance.com mobile app
  5. Jvibe92

    For Sale: TPMS transmitter tool

    Never used. Sells for 46.97$ on AmericanMuscle. Looking to get rid of for 40$ shipped or best offer. Works for 07-17 cars 281-629-5853 Sent from my iPhone using the svtperformance.com mobile app
  6. Jvibe92

    For Sale: Sound tune from a 13 GT

    Up for 20$ is anyone wants it?! Heard some like using it in the v6 crowd. 281-620-5853 Sent from my iPhone using the svtperformance.com mobile app
  7. Jvibe92

    For Sale: brembo front rotors/pads and rear rotors/pads (factory)

    Got a full set of rotors/pads that have been sitting in boxes in my garage for almost a year now. Was not going to sell but decided to free up space in the garage. The first picture shows the rears and the last few show the front. Has enough pad height to last awhile longer. 281-620-5853 is...
  8. Jvibe92

    Need help diagnosing Brembo Screeching

    I am having high pitched, demonic screeching coming from only my drivers side brembo. Here's the story to rule out some possible issues Bought factory brembo setup used Had rotors resurfaced before put on Had brembos powder coated Factory setup screeched bad, enough that I changed the...
  9. Jvibe92

    McLeod RST clutch sticking low rpm issue

    Hey Everyone, I have a very experienced shop install my McLeod RST and lightened steel flywheel. Works flawlessly. Buttery shifts all the way through 7.9-8k rpm. I do have one recurrent issue that I cannot find if it is common issue with Mcleod. Here is some descriptions. Shop installed...
  10. Jvibe92

    For Sale: OEM clutch and flywheel for MT82

    wanting to sell my oem clutch and flywheel used on my 2013 5.0 for about 30k miles. Clutch is working perfectly fine and there is no glazing. Went with an RST setup so that is the reason for sell. Located in Houston, Tx. Also selling drifts which is why I reused the paper! Contact me at(281)...
  11. Jvibe92

    For Sale: 18x9 and 18x10 Sve Drifts

    Selling my set of SVE drifts in flat black. They are (2) 18x9 and (2) 18x10. They are in almost perfect condition as I had them cleaned weekly. No imperfections on the out face whatsoever and yes they clear brembos. I went with forgestars so that is why I am selling. I am located in Houston,Tx...
  12. Jvibe92

    FS: Flowmaster Pro for 11-14 GT

    have a set of flowmaster pros collecting dust. Bought retail for I'm AM for $500 something. Perfect for those no love the FM sound but not crazy loud like outlaws CJ ne. Only has one defect that came from when it melted the plastic on my boss diffuser. Easy fix if heated up and scrubbed with...
  13. Jvibe92

    Mt82 rebuild. BG tranny fluid or?

    So getting my tranny rebuilt with an RST clutch also. Using stock flywheel since I do drag race as well as roll race. Anyone have any comments on using BG tranny fluid(syncro2)? How is it in the cold,etc?
  14. Jvibe92

    Clutch advice needed for cobra jet and potential nitrous manual

    What clutches outside of the RST or RXT are people running that allows for consistent 7800 rpm shifting? Looking to run nitrous in a few months after I break in the clutch. Right now making north of 450 to the wheels on my cobra jet set up. Ideally I need great street quality, minimal clutch...
  15. Jvibe92

    Pre-MT82 failure? 3rd gear on the way out?

    Well after this Friday, I think a tranny rebuild is close in my future. Going into 3rd under any load crunches and grinds. I even tested it by pushing the clutch all the way down and putting it into 3rd, and without releasing the clutch I got grinding. Thinking of getting it open and see what's...
  16. Jvibe92

    Advice needed in massive Brembo squeal(1 caliper only)

    I have been experiencing massive Brembo squeal. It occurred stock occasionally but now it's everyday. Setup is hps5.0 all around on xtreme slotted and drilled rotors. Both setups had the squeal only occur on the drivers front. Is this an issue with the Brembo? Here is an example video. Not my...
  17. Jvibe92

    IAT very high on cobra jet Setup?

    So today I noticed something different. Before, my IAT would be almost exactly ambient temp as soon as I would hit 20mph. After the cobra jet setup, while stopped it sits around 120 degrees on a 85degree day but it doesn't drop to the 80s until I run over 60mph for more than 5 mins or so. Anyone...
  18. Jvibe92

    need part Info on cobra jet install kit

    I forgot to buy the boss302 install kit for my cobra jet setup. Does anyone know the actual parts needed besides the 2ft hose? I see that we need a bolt, what size because LMR won't give me their specs lol
  19. Jvibe92

    For Sale: Bassani and Flowmaster Axlebacks for 11-14 GT

    Selling both the bassani and outlaws. I am in the process of finding an axleback that will fit my taste :) Will entertain trades if they are for flowmaster pros or corsas. The bassani's have about 80 miles on them and are in amazing condition. No defects whatsoever. Looking to get 425$ for...
  20. Jvibe92

    Muffler Hanger vibrating

    Been chasing a rattle and it turns out my drivers side hanger for the mufflers has a striped bolt that a mechanic must of done and the bolt just slides in and out of the hole. Tried a new bolt and it does the same. Is there any way to retread that bolt opening? Or am I screwed. The metal hanger...
  21. Jvibe92

    Need Insight on Bassani and Flowmaster Pro for LT no cat/res coyote

    Right now I have kooks longtubes and their offroad h pipe with lethal gen2 OAP. I tried kooks axlebacks and I don't like the sound. It's perfect for those who want to be middle of the pack in sound but I need more. I feel it's just too tame. How are bassani for loudness, drone, small load...
  22. Jvibe92

    FS: Lethal Offroad H/ OEM headers, cats, H pipe, and Etc

    Just installed my Kooks Longtube headers with their offroad H pipe so I have no use for my old setup and stock setup. No way I will go through the hassle to reinstalled everything! Every part has a box and is ready to be shipped when bought. My paypal is [email protected] For...
  23. Jvibe92

    advice needed for 18x10 tires

    Okay, so with my 3.73 and my 285/40 rear nt555, I roll through the traps hitting the limiter at 7500-7700. I want to bring this down with a taller tire so I can hopefully roll through the traps at 7000. How tall of a tire should I go? Is 295/45/18 going to be overkill? I actually want a streets...
  24. Jvibe92

    For sale: 11-14 GT Kooks axlebacks

    Posted this earlier in the week but was deleted for some reason? Posted below are some pictures of when I got them off the car on the 28th and an updated pic of them now. They are in perfect condition. Only reason I'm selling is because I'm going with flowmaster pro series. Price is 450 shipped...
  25. Jvibe92

    For Sale: Magnaflow Comp Axlebacks

    Looking to sell my Magnaflow Comp Axlebacks. Chose to go a different route and will be looking at getting flowmasters instead. Looking to sell for 450 shipped to anywhere in the US. The exhaust is in very good condition with no damage to the tips whatsoever. I am having issues uploading...

Top