......especially on an 8.8 solid axle with their eliminator kit? If so please sound off, I have a couple questions for you, particularly in regards to their axles fitment.
Brand new. 7/16 ARP 2000 bolts. 5.933 stroke. Comes with spec/inspection card and ARP lube. Really nice set of rods.
Part #: FD5933-866
$1400 shipped if on east coast.
**EDIT** 2/4/2022
Edelbrock "short" style water pump for GT/Cobra/Mach1. Part #8803. Brand new never used still in plastic. ($175 shipped)
Cleaning out the garage on a few nice items I won't be using. These are all brand new parts I intended to use on my 03/04 project but am switching up...
Any of you turbo guys happen to have a set (2) of the dowels that are used to line up the blower plate to the OEM intake manifold in your spares chest?
I'm assuming you're no longer going to need them - I am missing mine and need a set. Thanx.
Low mileage rack out of a 25k mile car. All boots and threads in good condition no leaks. Rack was lightly polished as i was prepping it to paint it black...its super clean...bores where bushings go have also been smoothed/polished.
$450....this is a large item so shipping will be on buyer and...
6k miles on them off my 04.
These are the XE266BH-116 nitrous/blower cams.
Serial numbers on cams are:
106-362-9LI
106-361-9LE
106-363-9RE
106-364-9RI
$850. These weigh about 40lb so shipping is dependent on your location.
Good working OEM brakes pulled from 25k mile 04 Cobra. Good pad life left if you wanted to run them as is.
No uneven pad wear, no leaky seals. Rotors could use a quick turn and ready to go.
Includes:
(2) 12.9in front rotors
(2) 11.6 rear rotors
(2) front calipers
(2) rear calipers
(4) OEM...
SOLD
6k miles on parts off 04’ solid axle cobra. CA car so no rust.
Kooks X pipe is full 3in
2.5in flow tubes into 2.5in Stingers
2.5in piping into 4in Borla tips. Piping is slightly dented on either side where it was touching my panhard bar but not bad.
Clamps and hardware included.
SOLD
An ever elusive set of the adjustable Cloyes secondary gears. Only Idled and removed. MMR billet secondary spacers brand new to lighten up the valvetrain.
175 shipped East coast. West coast add $10.
EV6 style with USCAR connector so these do not require adapters on most injector harnesses.
Freshly cleaned, flow-matched to under 2%, and factory sealed by Injector Dynamics.
I replaced two injectors bc they were just outside the 2% window but they are still very much usable - ID said a...
Selling as complete kit. Ready to bolt up. Just need your factory sensors / breather tube pushed into intake tube and vac line.
JLT lower fender mounted fiberglass tube. ID is 4in. OD is 4.5in. New 4.75in filter element. Intake freshly painted black. Bit of rash on bottom where it was rubbing...