Figured id post this here since you guys would appreciate it, got it done at tiger point paint and body here in navarre florida. Also had a Kaenan(sp) s281 spoiler put on and smoked heads and fogs. Did the bullet pedals last night and am installing a rear seat delete today. Car is finaly...
Went to the track last night and snapped an axle my first run. Pulled the rear end off today, im thinkin Detroit tru-trac,moser 31 splines,maybe some suspension stuff while the rear end is down. Opinions? Here is some pics:
Alright so i finally got the car to the track,best run was a 8.5 with a 2.4 60 ft...:??: ...problem with Holt is there is no way around the water ..so every car drags it all over the track..oh well no more excuses..only 2 runs..an 8.5 and a 8.8.., definatly alot of potential for a good time, i...
Video's have mods to each car in them, each vid has two races, one from a dig and one from a roll both to 120. All in all the car did better than i expected, from a dig it seems to be a monster, I won all races from a dig but lost all from a roll, you can tell they all had more power than me...
As the title stats, if anyone has a p/n for a poly trans mount for my t45, would you mind posting it or pm'ing me. Looked at a ton of different sites but can't seem to find one that will fit or get a straight answer from someone. Thanx - Sellinger
Just finished intalling the SLP loudmouth catback, decided to take her out for a spin,*stock H pipe and stock manifolds* ..I think it sounds pretty good let me know what you think.
http://www.youtube.com/watch?v=jpeMFQOWQtU
Me and a few friends did a little racing the other day just in fun, basically a few misc runs from 20 and 40, then a run with the ws6 from a dig and roll. The two cobra's are VERY close, and the ws6...well its about what i expected lol. - Info on all the cars are in the vid. Enjoy...
I am about to reassemble everything. Now do i have to leave the actuator hooked up? or can i get rid of it. I removed the butterflies and everything else from the plates. I have done searches and came up with conflicting opinions.-thanx sellinger
As the title states..im right in the middle of pullin my intake off for the first time and ran into some trouble. I got the bolts off the studs on the intake manifold that hold the assembly down..like my Haynes says to do..but then what? is there snap rings holding them down? or something the...
Looking for torque specs and such for my CFDF clutch install and spec billet steel flywheel tomorrow and can't seem to find any. No install information was sent with the parts and My Haynes manual is no help either. I know how to install a clutch just not sure on torque mainly. Any help would...