Had car dynoed the power curve is very choppy, car runs fine and isn't down on power. I replaced plugs and coils which made problem better but not fixed. Leak down and compression test are good also scoped cylinders everything mechanically looks good. A/f and boost is also where it should be.
I installed a new clutch and no engine lights I decided to to a cam relearn for precautions I did it with the ford Ids it stopped half way through and now have p0315 engine light on. Can't get the car to relearn with the Ids or the x4. Car has 10% overdrive, scj mono, JLT intake Lund tune, full...
Anyone running weld rts on front and rear with track package, I know I can change rear brakes and all that. I am looking for size (assuming a 17 or 18 rts) offset and if anyone has experience with them on a 13-14 track pack car?
As always thank you for your help
Darryl is off all week so I am dealing with Stephanie at Ace, I need a clutch for the car and being in Michigan there are very few days that its nice out so I would like to drive the car as soon as I can get a clutch in. My question is to the guys running the twin powercore clutch can you really...
Mods are 13-6 kit. When I don't lift shifting leaving it to the floor or quickly coming off gas then back in the rpms stay up and don't drop down for about 2-4 seconds. Is this clutch protection or a going bad clutch? Also in 5th gear at about 2k rpms rolling into the throttle the rpms raise...
I installed the bobs passenger side no problem, now working on the drivers side trying to figure hose routing that looks clean and that doesn't interfere with anything. Anyone have insight to this? Thanks
Just put a set of new tires on. Something a little taller and more sticky on the rear and that hopefully will wear better than the stock goodyears on the front.
just purchased a set of 1400 lumens diode dynamics fog lights for the Shelby and they will not seat properly in the housing they keep popping out. anyone else have this issue?
I am considering going to long tubes, I've heard that there is no bung for the o2 and you lose function of the wideband in the car? anyone confirm this?
Ive been looking at doing the corsa catback exhaust but it looks like a axle back setup with an x-pipe? also any benefit other than more noise with removing the resonators?
Has anyone used any of the trucarbon, seibon carbon fiber replacement parts? Looking at the replacement upper and lower grille, and the heat extractor. Looking for fit and finish feedback to anyone that has used. thanks for any help
Mike-
I have a set of 20x8.5 KMC GTX wheels and nitto 555 tires for sale tires have 200 miles on them (bought for a lot car never used them other than to display on used vehicle) I think 1200 obo was a fair price