kenne bell

  1. D

    2004 Terminatir with Kenne Belle SC VACUUM issue?

    Hi all, I thought I had a major vacuum issue and I couldn’t figure out where the leak was coming from. it seems however that it has something to do with this little blow hole? I’m not sure what it is. I inherited this from my father and I’m learning something new every day about it. Would...
  2. B

    FOR SALE: 2.1 Kenne Bell for 99-04 Mustang GT $3500

    Up for sale is my Kenne Bell kit i pulled off of my 99 2valve. Its a 2.1 intercooled kit with a 2.6 inlet and comes with a 3.25” pulley making around 9 psi.I used a CNC machine for the spacer between the blower and the manifold to fit this kit under a stock GT hood as long as you have the hood...
  3. Rezi

    Found a good deal on a 2.8 KB LC.

    Hello new member here, got my cobra last June 77k miles mild mods , had fun didn't know enough, long story short, should have done more research, ended up hurting it. Did a shit ton more research and now more aware of things for my car now, doing a build on it, the Eaton was steg IV ported, 2.9...
  4. D

    FOR SALE: 45k mile SB coupe $28,000

    Clean title car with under 46k miles. Tastefully modified. Specifics obtained from previous owner who built it are in the photos. Motor was built by Edison’s one off Customs at 38,000 miles or so, per previous owner. It has a race honed teksid block, stage 3 cams, new upgraded King bearings...
  5. D

    FOR SALE: 2003 SB Coupe, 44.5k miles, SRA, KB 2.8LC mammoth teksid block $30k

    Clean title car with under 46k miles. Tastefully modified. Specifics obtained from previous owner who built it are in the photos. It has a teksid block, stage 3 cams, KB 2.8LC mammoth. Motor has like 7k on it. 26 spline input shaft, 8.8 SRA with 31 spline axles and 4.10 gears. Subframe...
  6. K

    FOR SALE: Kenne Bell 3.2LC Supercharger

    For Sale: Kenne Bell 07-14 GT500 Supercharger 3.2LC MAMMOTH with 168MM Throttle Body. $4,295 OBO This supercharger was bought brand new and direct from Kenne Bell. It has never been used or installed and it is still in its original, unopened box. It was tuned for a 2012 Shelby GT500, which was...
  7. ATCzMustang

    What happened to the Kenne Belle Supercharger Kit for 99-01 COBRAs?

    Anyone know what happened or why Kenne Belle discontinued their supercharger kit for the 99-01 COBRA? As I understand it was just an 03 Kit SC, with about 1k in extra parts to make it compatible. I really like the look of this style of supercharger setup. I know one can do a 03-04 Eaton swap, or...
  8. vnmous93cobra

    FOR SALE: Whipple 3.4L

    Whipple 3.4L, low mileage unit in good working condition. It has a 3.5” pulley on it. What you see in the pics is what I have to go with it. $3,250 obo plus shipping or trade for a twin turbo kit. I am happy to meet to avoid shipping if you are in the greater Houston area.
  9. S

    WANTED: WTB Comp Orange or Black coupe west coast

    I am located in Seattle but am willing to travel a decent distance for a competition orange coupe, or for the right black coupe. Cash in hand ready to buy.
  10. L

    2003 Oxford White Cobra w/ 2.3 Whipple

    2003 Mustang Cobra Oxford White 53,000 miles. I bought this car in San Diego from another member here in 2012 with 44,000 miles. Engine 2.3 Whipple supercharger (1st gen) K&N air intake Accufab single blade throttle body LDC Head cooling mod Nations 200 amp high output externally regulated...
  11. A

    2008 GT500 Local pickup only Salvage title

    2008 GT500 Vapor silver. 10,000$ firm, engines perfect, kenne bell 2.8lc. Not sure why they are totaling it. But I have a build list for this car. It was in a 40mph accident where it went up on the curb. Frame is not bent. I need 10,000$ up front to buy it back from the insurance company. And...
  12. Carlos A Melgar

    Might be selling my 3.6 kenne bell

    Might be selling my 3.6 kenne bell for i put about 1500 miles on it. Comes with everything it except fuel rails or injectors can possibly throw them in for a good price. The blower comes with a 3.50 pulley also have a 3.75. it will come with a dual 75mm kenne bell throttle body with electronics...
  13. R

    Teksid TFS 195 2V KB 2.8 Mammoth Build

    New Engine Build by Addiction Motorsports in Simi Valley, CA: Engine: Trick Flow® Race 195 Cylinder Heads ~9:1 Compression (91 CA Octane/Pump E85) .020 Over Teksid Block 2618 Forged Pistons with ,200 Pin and Trick Flow Valve Relief MMR Billet Main Caps MMR Billet Tensioners, Timing Chain...
  14. Joe Chahine

    GARAGE SALE, AFCO, KB, METCO, ISO

    ** Update ** Taking best offers. Reviving this for sale thread, taking best offers. Money got a bit tight with this Coronavirus. Half the fam was laid off so gonna also be putting up other things for sale on separate threads. Most of the parts 4 sale are from my Fox-Termi swap project that I...
  15. S

    GT500 randomly holding high idle?

    I have run into a problem with my 2010 GT500. I daily drive this car and have never had a problem with it but the other day I was driving at 2400 rpms and when I let off the gas, the rpms stayed at 2400. I pushed the clutch in, they did not drop. I had to turn the car off and it started up fine...
  16. K

    Help Mechanic replaced FUEL SYSTEM NOW CAR WON'T RUN!!

    Please help, as I had a mechanic who has absolutely ruined my car. According to him he installed 2 Walbro 450's and bypassed the FPDM with the wiring that Lund has stated is not a normal way to wire. According to the mechanic the car runs great just the boost drops during a pull for data...
  17. R

    03 DSG Cobra with Extra's - updated

    I’m looking to let go of my 03 DSG Cobra with $3.4K in extra part$ Located in zip code 44406. Message me if interested and I can reply with additional information. I’m the 3rd owner and have had it since 2008. First owner was a female, and second was a father/son. All modifications done below...
  18. B

    WTB: Supercharger - open to all makes and models

    Looking for an upgraded supercharger from stock, open to all makes, models and sizes. I may also consider ported eaton’s, post up what you’re looking to sell! (PayPal ready/cash in hand) located in Long Island, NY.
  19. B

    WTB: Supercharger - open to all makes and models

    Looking for an upgraded supercharger from stock, open to any makes, models and sizes. I may also consider ported eaton’s, post up what you’re looking to sell! (PayPal ready/cash in hand) located in Long Island, NY.
  20. M

    Kenne Bell Cold Air Intake $125

    I have a Kenne Bell CAI off my GT500 for sale, I recently upgraded to the "Gimme 5" intake and no longer need this one. It fits 2007-2012 GT500 with oval TB. The tube is chrome, I just plasti-dipped it black to match my car. Asking $125
  21. Xwardbl

    2014gt500 kb 3.2lc coolant lines tie in's?

    Installing the kennel bell 3.2lc on my 14 gt500. Kit comes.witg instructions for older gt500. Has anyone put this kit on there 13 or 14? Maybe have pictures of where the coolant lines from super charger tie in to intercooler tank.
  22. 4

    Kenne Bell Supercharger Pulley Billetflow 2.93

    Used, 2.93 inch Billetflow supercharger pulley for a Kenne Bell Supercharger that uses an 8 rib pulley. $70 shipped with tracking.
  23. H

    2003 Kenne Bell Cobra F/S

    The car has been meticulously maintained. Best of everything on this car. Car was built by HPP Motorsports out of Dallas Texas (from the show street outlaws) . The car makes 660 hp at the wheels on race 93octane and torco fuel additive.The car is an absolute rocket. 56xxx on car 12xxx since...
  24. D

    Which Blower?

    I currently have a built 2v motor in a 04 GT with an Eaton m112 blower. Teksid block. Forged internals. Im making around 450hp with the current blower at 12psi. My motor and fuel system were built to handle 700+ hp but I skimped on the blower during the build. I'm looking to upgrade now and...
  25. K

    HELP!! Lean and inconsistent.

    Let me start by saying hello!! I have been reading on these forums as well as others for a while now. I have been given a lot of really good ideas thru this forum and members without having ever communicated directly. I recently just joined, and I am completely open to any and all criticism or...

Top