Hello, I recently finished a swap to a terminator motor and on the dyno it is running very lean, mechanic says i need a new fuel pump. So, my question is would this one work...
Hey guys, new here but I've been trying to read and search for a couple weeks now to no avail.
To the issue, I've got a 99 cobra vert and I am doing a terminator swap on it. I have everything, all harnesses, engine, tranny, driveshaft, gauges, fuel tank, the works. Now, my question is, do I...
selling the IRS from my 04 Cobra. It has 4:10 gears inside, H&R race springs and Koni shocks upgraded polyurethane bushings. The gears where whinny (what 4:10s aren't) but the irs is in complete working order.
Shipping this item would be bananas therefor im looking for a local buyer or someone...
Sorry if this has been covered already, but I couldn't find exactly what I was looking for. I have a 2001 Cobra that I obviously want to supercharge. Now I know about eaton swapping and I know there is a guy on here that can sell kits for like $3000 which is cool, but I don't know if I should...
2001 Bullitt Mustang #4593
Roughly 35k on car, 25k miles on Engine & Transmission
Car was in a flood while down south in Camp Lejeune. Had just put a Vortech supercharger on the original 2 valve motor and was at the tune shop on the dyno when a tropical storm came through. Car took...
1993 hatch origanaly a 4 cyl car 93 cobra clone to the tee. i built the car from the ground up. the best of the best was used in this build no corners cut , this is a 100% street car A/C works and performs wehn needed dyno and track number to back it up . Now for the good stuff, under the hood...
Looking for a 03/04 "terminator" engine and tranny auto for my 01 gt. Looking to swap for the terminator engine. Anyone help me out on where to find one?
Have a complete eaton swap including
timing cover
pulley bridge with pullies
home ported eaton tb/plenum (painted black needs to be painted).
Stock eaton tb/plenum
N2o plate for blower
Metco 4# lower kit
Metco 2.8 upper pully
stock upper pully
metco Belt wrap pully kit
Correct length...
This is an 03 cobra driveshaft hooked up to a t56 in a 98 cobra that has had the mount moved forward 1". The yoke has been swapped to the 98 yoke using a hybrid u-joint. Suspension is hanging if that makes a difference.
Does the spacing look okay?
I'm doing an 03 cobra into a 98 cobra motor/trans swap.
I'm using the 98 wiring and computer.
I bought a spare '98' cobra engine harness that has worked perfectly except one connector near the main bulkhead on the passenger side.
It sits between the main connector and the strut tower.
On the...