timing

Hello everyone! I'm here for a smidge of advice, where ever I can find it. I have a Gen 1 coyote which I just recently pulled out (mainly for TKX swap). I mostly focused on heads and timing. It got new lifters, MMR springs/retainers, billitt oil pump/crank sprocket, pickup tube, windage tray...

Hi All! Here for a bit of help again.. Tore down the '99 motor and am in the process of rebuilding. I'm though the "hard stuff" inside and have a couple things to verify before I get too far. 1. Timing Chain Tensioners: The 99 has the iron ones, supposedly more robust. With about 70k on them...

I have tons of DOHC timing chain, lash adjuster, cam followers if you need something not listed PM me I may have it! Lets start with the following: Lot No 1 Used DOHC Set ~ 3,000 Miles Asking $225 obo Shipped via USPS As in 2 engine pics below, getting ready to remove from running 97 Cobra...

I have tuned my car with SCT Pro racer, and just converted my car to E85. I have full bolt-ons and a ported Eaton with 2.8 upper and 4 lower pulley, making abount 17 psi. I am woundering how the timing chart should look like, right now I am running the timing chart from SCT on race gas tune...

You guys are probably getting sick of my questions but.. I'll ask anyway. I'm currently running a TVS with a 2.8" pulley, 16.5* of timing, and 93 + booster. I have a heat exchanger on the to-do list to get IAT2 readings down, but I'm debating a smaller pulley. When I originally got my Cobra...

<edit> I have one primary question. Read everything below if you like, but I primarily want an answer to the following question: Those of you with TVSes running 93 octane, at what IAT2 does your tune start pulling timing? ------------------------------------ I'm trying to determine how the...

Hey guys, ill try to summarize as best as i can. Recently my 08 mustang gt (mods intake, full exhaust, tune) started randomly making a loud engine rattle noise, started out just when I would come to a stop or below 3k rpms but then got more frequent, I pulled codes and got p0022 (timing over...

Part # is TFS-51800500. Cheapest I can find it is $329, I'll sell it for $300 shipped to lower 48. This is New still in the Summit ordered box. I did not need this and I ordered it last year, therefore cannot return. I'm cleaning out the garage and need this gone. Best offer takes it. Location...

I have a 93 F-150 that I just bought and I am doing a tune up on. My question is how do I check my timing when my balancer only has one big notch with no other degree marks or a crank pointer?

Sold!

i'm doing a 4v swap in my 04 gt, i'm rtying to piece together the rest of what i need to finish it up. i am running a mmr900 short block and ported 96 cobra bheads. parts i need: 96-98 cobra intake manifold (preferably short runner or sheetmetal if anyone has one) coolant crossover tube...

I need some help guys. I am starting my engine build and need a Terminator timing cover. I originally wanted an Aluminator engine that comes with a new timing cover but decided to go with a Boss330 engine that requires a new timing cover. Please, if you have one or know of someone that may have...