03 Cobra 4.6 FULLY BUILT 4V motor. Blower to Pan

[JLMoldingDesign]

Hillsborough, NJ

I am putting up for sale a COMPLETE 4V 4.6motor. The motor has about 1500 miles on it and just had a complete fresh up job and valves adjusted from a highly reputable engine shop in PA. This engine put down 700Hp/600Tq at the wheels, revs to 7200Rpm on 93 pump gas. (Decided to build a Coyote / turbo / auto trans setup)

Engine was completely torn down at 18k original miles and had the following upgrades-

Engine – Built by Big Daddy Performance, Lakewood NJ
Custom Manley 2618 forged piston w/ HD wrist pins
H-beam rods
AP steel file fit rings
ARP main studs with full tray
ARP main side bolts
TSS Billet gear HV HP oil pump w/pickup
Cometic head gaskets
HP main bearings
HP Rod bearings
FRPP timing chain kit
ATI balancer
Metco lower pulley kit
Balanced and blueprint polished crank
60# injectors
Reische 170 thermostat
Cylinder cooling mod
Heads
TEA ported 4v heads w/ Ferrea stainless valves / Valve springs
Titanium retainers
Custom blower cams
Adjustable cam gears
Whipple 2.9 supercharger
Gates Fleet Runner supercharger belt
Kooks 1 3/4 long tube headers with x-pipe and cats
Custom fuel system
Dual 340Lph fuel pumps
Teflon lined fuel lines #10 Feed #8 return
Black anodized fuel rails and fittings
Aeromotive Pro EFI regulator
MIL Eliminators
EGR delete Kit
NGK plugs
Paid $17900

Serious inquires only -
Conservative tune on 93 pump. Easy to make 800Hp+ with race gas. Motor built to 1000Hp.

PM me for contact info.

 

[Shadow Grey 03]

Hell of a combo here

 

[1996MysticSnake]

If you start to part it out i'd be interested in the short block.

I'm close enough to pick it up so no shipping.

Sent from my moto x4 using Tapatalk

 

[JLMoldingDesign]

Shoot me a text. 908-208-1963
John

 

[96GT226410]

That is awesome. If I had the cash this would be mine. I'm in NJ, too, I wonder if I could convince the wife. Ha ha... Good luck with the sale.

Sent from my SM-G935V using the svtperformance.com mobile app

 

[4sdvenom]

If you decide to separate it a little I would like a price for the longblock. I would only need the longblock nothing else.
BTW
What compression is it and what engine block?
DC or DB heads?

Thanks

 

[JLMoldingDesign]

Bump

 

[theboss281]

If you decide to separate , I am interested in , Kooks 1 3/4 long tube headers with x-pipe and cats

 

[Davemig]

Price?