The time has come to sell my car. I wanted to see if there's any interest in it as it sits vs taking it back to stock-ish. roughly 6200 miles. title in hand. 53k.
Options include Electronics Package and heated seats.
165 silver coupes in 13. of those 33 had blue stripes and of those 16 were non performance pack. That's about as far as I can break it down. Another way is of the 165 coupes.....7 had heated seats.
Purchased in December 2012. Initial round of mods done in December 2013 includes headers, catted H, upper pulley, TB, CAI and tune. Final round of mods done in August 2014 included cams, ID1000's, BAP, catless H, clutch, stainless clutch line, pilot bearing and Lund remote dyno tune. all work performed by Kinetik Motorsport here in Houston. Have all stock parts.
Engine
L&M custom grind comp cams
VMP twin 67 TB
JLT CAI
2 psi upper pulley
black Moroso coolant tank and intercooler tank (installed by me)
JLT passenger side oil separator (installed by me)
Exhaust
ARH 1 7/8 headers
ARH catless H-Pipe
stock over axle and mufflers
Misc
Spec P-trim clutch kit
KB 17.5v BAP
ID1000 injectors
305/35R20 Nitto 555 drag radials
It does have a spot in the windshield from where a rock flew up during a Shelby cruise. on to the pics and vids:
I'm sure I'm forgetting something so I'll keep this post updated as I remember. Thanks for looking.
Options include Electronics Package and heated seats.
165 silver coupes in 13. of those 33 had blue stripes and of those 16 were non performance pack. That's about as far as I can break it down. Another way is of the 165 coupes.....7 had heated seats.
Purchased in December 2012. Initial round of mods done in December 2013 includes headers, catted H, upper pulley, TB, CAI and tune. Final round of mods done in August 2014 included cams, ID1000's, BAP, catless H, clutch, stainless clutch line, pilot bearing and Lund remote dyno tune. all work performed by Kinetik Motorsport here in Houston. Have all stock parts.
Engine
L&M custom grind comp cams
VMP twin 67 TB
JLT CAI
2 psi upper pulley
black Moroso coolant tank and intercooler tank (installed by me)
JLT passenger side oil separator (installed by me)
Exhaust
ARH 1 7/8 headers
ARH catless H-Pipe
stock over axle and mufflers
Misc
Spec P-trim clutch kit
KB 17.5v BAP
ID1000 injectors
305/35R20 Nitto 555 drag radials
It does have a spot in the windshield from where a rock flew up during a Shelby cruise. on to the pics and vids:
I'm sure I'm forgetting something so I'll keep this post updated as I remember. Thanks for looking.
Last edited: