how much rear wheel horsepower power will a triple 465 setup support on E85
3 walbro 465’s
- Thread starter xxjaymanzxx
- Start date
Each 465 is good for around 580ish rwhp on e-85 without a voltage increase. Increase the voltage ive seen 1 465 run 900whp.
If your running 3 you should be able to push 1700ish rwhp with them at normal voltage on E-85 without any issues. Dats a lot of pump dude.....
Two 465 will give you 1200ish rwhp on normal voltage table.
What are you running some 2000cc injectors?
I have id1000’s at the moment and will be good for now but I’m looking in the future I want to go turbo and e85, my motor is built and I’m switching to e85 soon and have to upgrade my hat and pumps so I might as well go big now so I don’t have to redo it again in the future
A single 465 is at about 80% duty cycle at 500 hp so around 1500 hp approx. Depending on Dyno. ID1300's will be maxed out there. 1700's would be required at that level but ur idle and low speed drivability will suffer.
Do u have a FORE set up? If u have the double pumper u can send it in to FORE for a $150 to upgrade to the triple hat but thats only if ur set up is no more then 3 years old. Mite be a cheaper option for u if u already have a FORE DP setup.
I do have a fore setup but but I think I’m gonna stick with the double setup because 1200 is more than enough than I would need I would just have to get bigger injectors at that point
Users who are viewing this thread
