94 HCI 5.0 stalling when put in gear?

helldiver14

Member
Established Member
Joined
May 19, 2016
Messages
38
Location
Dayton
Hi I have an HCI 94 5.0 AODE I built in 2014. I recently decided to re-do the lower intake as it was leaking(cold start idle surge and strong exhaust smell). While in there I noticed I had a chewed injector wire so I replaced that. Got it all put back together after having to redo the distributor (forgot to mark it) and idles like a dream. Problem is as soon as I put it in Drive or Reverse it dies. Doesn’t even try to stay running, just dies. It will run if I give it just the big toe of gas while in gear (1000rpm). Any ideas? I ordered a new TPS and IAC. Didn’t do this prior to replacing the lower gaskets. Went into gear fine with the intake leak.

-Timing set at 16 with spout out
-vehicle was dyno tuned in 2014 as well
 

Users who are viewing this thread



Top