Abs delete block

[D-MANN]

I just installed the Infinite Machine concepts abs delete block and I have three lines that leak ever so slightly. Anyone else have this problem? I ran out of time last night but will unbolt the lines again and try to get them to seat properly.The nuts are tight but don’t seat on the block flat. someone mentioned fuse(s) that need to be pulled once deleting the block but I can’t find any info on anyone having to do that.


Sent from my iPad using Tapatalk Pro

 

[P49Y-CY]

I believe its a good idea to pull the fuse(s) because you are essentially just leaving the harness in place with the end taped off.

 

[01yellercobra]

Back off the fittings and re-tighten them a couple times. It'll cause the flare to reform a bit for a better seal.

Misspelling brought to you by Tapatalk

 

[Phill]

The brake fitting wrench nut is not suppose to seat flat on top of the surface, the seal is between the bottom angled ports and the metric bubble flare brake tube. If the bottom of ports are not machined at the correct angle, then this can also cause a small leak.