Blow off Valve with 3.48 pulley

[RFM50]

Did any of you that changed to a 3.48 pulley with your paxton, swap out your blow off valve? If so what did you switch too.

 

[Sof Top]

I ran the 3.48, but kept the stock bypass, with it became moe noticeable with the 3.48. There are a couple Paxton guys on here that did the Tial blow off though.

 

[RFM50]

Ya I have been debating if I want to switch. I just took the filter off of my bov today and discovered the o ring to the plunger broke.

 

[blackbeast12]

What' the major difference between the tial bov and the stock paxton bov?

 

[mustang_guy]

Subscribing

 

[RFM50]

I actually found out from Paxton that the factory blow off valve is good up to 18lbs

 

[13DIB5.0]

I have the tail q with mine on 10lbs. its very loud, my buddy with the stock one, u cant even tell its there, nice for a sleeper look but that wasn't what I was after

 

[manolith]

Is tail better than a mondo?

 

[SNSTR50]

I'm curious about this also

 

[beefcake]

I have the Vortech BV57's which flow 1300 CFM's.

Very nasty!

Satin or polished

 

[blackbeast12]

Did a little research and here is a way of knocking 30 db off your bov, its a pneumatic muffler, here's the link:

SMC