Breaking In L&M Engine dyno numbers

[Derek5774]

We put my car on the dyno today just to break in the motor and check everything. I was a bit shocked at what it made.
980hp 800tq at 15 psi the lowest boost it can make


A few more mods and we will turn this beast up, stay tuned for final numbers before the Texas Mile

 

[scottGT500]

Wow! Did you swap clutches at the same time? I have to break in my L&M motor AND Spec clutch at the same time...hope the clutch holds lol...

Your car is nuts!!!

 

[Derek5774]

I already had a Spec P-Trim

 

[scottGT500]

I already had a Spec P-Trim

Gotcha, thanks!!!

 

[BOSSPOWER]

Nice Derek, good luck!

Manuel

 

[stkjock]

Damn!


Full long block build? Heads, cams?

 

[MovingZen]

Wow.. no wonder it sounded so damn good!

 

[Jcobra03]

nice

 

[NELCO]

Derek...............Nice numbers.................... I wish I could make it to the texas mile this year to watch you run.... Turn up the wick......................... Nelco

 

[Derek5774]

Damn!


Full long block build? Heads, cams?

Yes
L&M cams and slawko ported heads

 

[stkjock]

Very nice!

 

[Derek5774]

Thanks

I'll post up numbers when we do the cooling system and pulley it up

 

[5.8MysticCobra]

Specs on the motor and what blower are you running and fuel , nice baseline numbers

 

[Derek5774]

Specs on the motor and what blower are you running and fuel , nice baseline numbers

Kenne bell 3.6
E85

L&M custom cams
Slawko ported heads
Built bottom end

 

[1320 Junkie]

Whats the current pulley combo?

 

[Derek5774]

Whats the current pulley combo?

10% lower. 4 inch upper

 

[1320 Junkie]

10% lower. 4 inch upper

Impressive...thats normally 18-19psi rotor speed.

 

[Derek5774]

Impressive...thats normally 18-19psi rotor speed.

It was 19 psi on stock motor

 

[blitz1029]

That's crazy with only 15 psi. Who built your motor?

 

[MikeHoncho]

That's crazy with only 15 psi. Who built your motor?

Pretty sure the title says "L&M Engine"...