• Welcome to SVTPerformance!

Cam Degreeing, Install question. Need advice.

Discussion in 'Boss Series Engines' started by darreng505, Oct 22, 2014.

  1. darreng505

    darreng505 New Member Established Member

    Messages:
    1,314
    Joined:
    Dec 28, 2012
    Location:
    Washington, DC
    Hi,
    So what is the standard process for installing/degreeing a set of custom cams to get the best power curve?
    I have 2012 Boss 302 and bought some custom cams with lockouts. The installer just used the default values
    on the cam cards and put the car back together. The power curve is poor.

    Should they have done a trial and error process with the cams open to degree them properly irrespective of
    the cam cards?

    How is this normally done? Or should have been done? Is the install normally done while on a dyno to get the power numbers?

    Need advice. Thanks.
     
  2. Dizzyscure1

    Dizzyscure1 New Member Established Member

    Messages:
    1,750
    Joined:
    Mar 18, 2012
    Location:
    Louisiana
    Bump
     
  3. Willie2

    Willie2 Well-Known Member Premium Member Established Member

    Messages:
    2,504
    Joined:
    Jul 23, 2008
    Location:
    Houston

Share This Page