Cobra enigine swap

pyro1998

Member
Established Member
Joined
Dec 12, 2014
Messages
94
Location
tn
I need some help, I have installed the complete engine, transmission, wiring, computer....... everything it would take to make this run in my 02 GT. I got it all in and the motor would just turn over "the PATS" was killing me. So I got a tune to remove the offending PATS and now my car will "RUN" but the windows don't go down and radio will not work, any ideas out there?
 

BlksvtCobra01

Deplorable and Proud
Established Member
Joined
Apr 10, 2008
Messages
13,559
Location
Ohio
In the front fender if I remember right.


Sent from my iPhone using Tapatalk
 

hotcobra03

Well-Known Member
Established Member
Joined
Mar 11, 2007
Messages
7,468
Location
poteet,texas
I would assume it's something other than swap..

I would start with fuses and grounds..

wiring diagram will show wire color to check at radio connector to confirm power getting there..

gem is located in kick panel on drivers side if I recall from reading..

the ground at pcm might be shared with these items..

in sticks you will find full pc version of the service manual..

here will have all the tiny details..
 

pyro1998

Member
Established Member
Joined
Dec 12, 2014
Messages
94
Location
tn
Now I have found that the keyless remote from the 02 gt is still working the locks, trunk release and panic alarm, this would not be so if all the modules were replaced correct?
 

Users who are viewing this thread



Top