• Welcome to SVTPerformance!

Cobra t-56 in v6 using cobra crossmember?

Discussion in 'SN-95 and New Edge Mustangs' started by Caden807, Apr 26, 2020.

  1. Caden807

    Caden807 Member Established Member

    Messages:
    39
    Joined:
    Apr 23, 2020
    Location:
    Kentucky
    I have a 2000 v6 that I am in the process of LS swapping. Was wondering if anyone had swapped a t-56 out of an 03-04 cobra and used the stock mount. If not, any recommendations on a good swap crossmember?
     
  2. Corbic

    Corbic Well-Known Member Premium Member Established Member

    Messages:
    4,360
    Joined:
    Apr 14, 2015
    Location:
    Midwestern Hell
    Don't see why it wouldn't work. You'll need a bell housing correct input shaft for the LS Engine.
     
    Caden807 and me32 like this.
  3. me32

    me32 BEASTLY SHELBY GT500 TVS Moderator

    Messages:
    14,649
    Joined:
    Sep 6, 2005
    Location:
    CA,NorCal
    Why? If your gonna LS swap use the T56 from LS. Its already a 26 spline.
     
  4. Caden807

    Caden807 Member Established Member

    Messages:
    39
    Joined:
    Apr 23, 2020
    Location:
    Kentucky
    I was going to go that route but they have a hydraulic clutch. I could get pre 98 and be manual, Thinking about doing that.
     
    me32 likes this.
  5. me32

    me32 BEASTLY SHELBY GT500 TVS Moderator

    Messages:
    14,649
    Joined:
    Sep 6, 2005
    Location:
    CA,NorCal
    There T56 was actually stronger and different gear ratio. Its actually nice to run 4.10s, 4.30, 4.56 with that trans. .50 6th gear
     
  6. DSG2003Mach1

    DSG2003Mach1 Well-Known Member Premium Member Established Member

    Messages:
    9,751
    Joined:
    Apr 15, 2004
    Location:
    Central Fl
    stifflers also makes a bolt in cross member for the T56 with a drive shaft loop
     
  7. Caden807

    Caden807 Member Established Member

    Messages:
    39
    Joined:
    Apr 23, 2020
    Location:
    Kentucky
    Yes, the 94-97 is .50 6th gear I believe.
     
  8. Caden807

    Caden807 Member Established Member

    Messages:
    39
    Joined:
    Apr 23, 2020
    Location:
    Kentucky
    Thank you! Do you know if that is the one that has been discontinued?
     

Share This Page