• Welcome to SVTPerformance!

Coil spring postition (orientation) ride height, new one on me?

Discussion in 'New Edge Cobras' started by FIREBALL, May 24, 2020 at 12:08 AM.

  1. FIREBALL

    FIREBALL Member Established Member

    Messages:
    292
    Joined:
    Mar 5, 2016
    Location:
    Calif
    delete
     
    Last edited: May 24, 2020 at 3:41 PM
  2. 01yellercobra

    01yellercobra AKA slo984now Established Member

    Messages:
    15,980
    Joined:
    Oct 5, 2005
    Location:
    San Diego
    The posts you're reading are for an SRA. It's been a awhile, but I think the lower control arms for the IRS have pockets for the springs to fit in.

    You might be able to tweak height a little side to side, but its not something I've tried.
     
  3. shurur

    shurur Well-Known Member Established Member

    Messages:
    2,812
    Joined:
    Jan 2, 2011
    Location:
    Tampa FL
    Without going outside right now..as I recall....they both start in the lower cup right in the middle of the tab where the emergency brake cable bracket is..

    or on the 99..where the bracket should be.

    Outside (FIX:REAR) forward wheel well..you will see the wide tab on the arm and the protective metal ring on the emergency cable that corresponds to it.

    Also..on the 99, tie wrap the emergency brake cable at that same point through the spring cup hole with some big honking tie wraps in place of the brackets that came on the 2001+ cobras.
    you can wrap the cable with some rubber split hose 5/8"..gooped with permatex ..if you want.

    The front springs should start right between the two spring cup weep holes.
     
    Last edited: May 25, 2020 at 8:19 AM
  4. FIREBALL

    FIREBALL Member Established Member

    Messages:
    292
    Joined:
    Mar 5, 2016
    Location:
    Calif
    informative--I think?
     
    Last edited: May 25, 2020 at 12:31 PM

Share This Page